Notes On Digital Operation; Controllable Functions - Trix RAe TEE II Manual

Function
• Built-in electronic circuit for operation with a conventional
DC power pack (max. ±12 volts), Trix Systems, Trix Selec-
trix or NMRA DCC digital systems.
• Automatic system recognition between digital and analog
operation.
• SoftdriveSinus propulsion with a maintenance-free motor
• No automatic system recognition between Selectrix (SX)
and DCC.
• The full range of functions is only available under Trix
Systems and under DCC.
• Headlights for the locomotive change over with the
direction of travel. They can be turned on and off in digital
operation.
• Depending on the length of the train, a stop or braking
block must be relatively long, so that the train will remain
stopped as desired.
Notes on operation with direct current
• A filtered direct voltage is required for operation.Operating
systems with pulse duration control are therefore unsuitable.

Controllable Functions

Headlights / Red marker light / Interior lights
Sound effect: Station announcements
Sound effects: Locomotive whistle
10

Notes on digital operation:

• The first time the locomotive is used in a digital system (Selec-
trix or DCC), the decoder must be set for this digital system. To
do this, the decoder must be programmed once in this digital
system (Example: changing an address).
• The operating instructions for your central unit will give
you exact procedures for setting the different parameters.
• The values set at the factory were selected to guarantee the
best possible running characteristics.
• This locomotive comes from the factory programmed for
the digital address „01" (Selectrix) / „03" (DCC) Number of
speed levels that have been set: 28 (DCC) and 31 (Selec-
trix).
• Correct programming with the 66920 Mobile Station is
possible starting with version number 034.
• Information about DCC Operation:
The setting done at the factory does not permit operation
with opposite polarity DC power in the braking block. If you
want this characteristic, you must do without conventional
DC power operation (CV29 / Bit 2 = 0).
Analog Central Control
DC 2000
Headlight button
Continuously on
—
—
1
STOP
Headlight button
— Button 2
— Button 3
5
systems
mobile station