Multivet Virtual Fence DSP13201 User Manual page 10

Training can be very tiring for your pet so limit training periods to 10 or 15 minutes. Also, let
other family members share in the training so that your pet doesn't relate the training to only one
member of the family.
Step 1: Where to start
Holding the Pet Containment System receiver collar in one hand, walk your pet to the Pet
Containment System boundary. The pet should not be wearing the Pet Containment System
receiver collar at this point. The pet should be wearing a regular collar with a lead only. Shake a
boundary flag and give your pet a strong "NO" command, allowing it to hear the beeping from
the Pet Containment System receiver.
Step 2:
Lead him back to a "safe" area and praise him.
Step 3:
Repeating steps 1 and 2 continue around the boundary.
Step 4:
After a short rest/play period, place the Pet Containment System receiver collar on your pet (this
is in addition to the collar with the leash).
Step 5:
Let your pet experience a "correction" by walking into the signal field on his own. Then,
immediately lead him back into the "safe" area and praise him. Shake the boundary flag again
with a strong "NO" command.
NOTE: The person doing the training should not encourage the pet to cross the boundaries, as
this will confuse him. (If the pet will not venture into the signal field on its own, have someone
else cross the boundary and allow the pet to follow. It needs to feel the correction to ensure the
boundaries are recognized).
Step 6:
Repeat step 5 again around the perimeter boundaries.
Your pet should receive a "correction" only when it willingly attempts to cross the boundaries.
Step 7:
Remove the Pet Containment System collar. DO NOT leave your pet alone with the collar until
fully trained.