Installation - Electrolux EHE6879 User Manual

Cabinet Leveling & Refrigerator Door Alignment
(if necessary)
Guidelines for final positioning of your refrigerator:
• All four corners of the cabinet must rest firmly on the floor.
• The front should be slightly elevated to ensure that doors
close and seal properly.
• Doors should align with each other and be level.
Most of these conditions can be met by raising or
lowering the adjustable front rollers.
To level the cabinet using the front rollers:
1. Slightly open freezer drawer if the toe grill is installed. Lift
the toe grill and gently pull forward.
2. Make initial cabinet adjustments by using the front roller
height adjusting screws. Use a 3/8 inch socket wrench to
turn the adjustment screws (1 per side).
To raise: turn adjustment screw clockwise.
To lower: turn adjustment screw counter clockwise.
3. Ensure both doors are bind-free with their seals touching
the cabinet on all four sides and that cabinet is stable.
4. After unit is leveled, lower anti-tip leg using a 3/8 inch
socket wrench until it firmly contacts the floor.
To make final door height adjustments:
1. Open freezer drawer to make lower hinge visible.
2. Insert 6mm Allen wrench into the shaft of the lower hinge.
3. Adjust the height by turning clockwise or
counterclockwise. Turning clockwise will lower the door.
Turning counterclockwise will raise the door. Default
setting is to the lowest height when you receive your
appliance.
Raise
Flipper Mullion
Adjust Flipper Mullion for proper connection with the
mullion guide by ensuring the flipper mullion is folded
and perpendicular to the fresh food door. If the
mullion guide is not in the correct position, it could
prevent the door from closing completely.
Installation of air filter (selected models)
The air filter is located in the top center of the fresh food
compartment.
To ensure optimal filtering of refrigerator odors, you
should change the air filter every six months. Your first
complimentary air filter can be found in the crisper.
1. 1. Remove the air filter cover by squeezing the sides of
the cover together and removing from liner
2. 2. Remove the old filter and discard it.
3. 3. Unpack the new filter and slide it into the housing.
The open face must (carbon media) of the filter
should be installed facing the air port (hole) in the
multiflow.
4. 4. Replace the air filter cover by squeezing the sides
and snapping it back into place.
6 6
WRONG
Air Filter