Dimplex DXLWP400TS Installation And Operating Instructions Manual page 4

Model Name
DXLWP400TiE7
DXLWP800TiE7
DXLWP800TiE7B
DXLWP400TS
DXLWP800TS
IMPORTANT
-
MUST NOT BE PLACED ON THIS HEATER.
NOTE - This product is suitable for background
heating only.
Before using the heater ensure that all warnings
and instructions have been read carefully.
Models with Thermostat Dial only– DXLWP400TS
& DXLWP800TS
DXLWP400TS & DXLWP800TS models are fitted
with an adjustable thermostat allowing the back-
ground temperature to be controlled by adjusting
the setting accordingly. The thermostat has a
minimum setting, which can be used as a guard
against frost. Provided that the controls are set to
a heating function i.e switched ON, the heater will
come on when the surrounding temperature falls
to approximately 5˚ C (41˚ F). Turn the thermostat
knob to the highest position to warm the room to
desired level. When the room temperature has
reached the desired level, turn the thermostat knob
back slowly until the thermostat just clicks off. The
heater will then
temperature at the chosen level.
NOTE - Should your heater fail to come on when the
thermostat is at a low setting, this may be due
to the room temperature
thermostat setting.
DXLWP400TS & DXLWP800TS - 1 Switch
The switch on the side of the heater turns the
heater on. Note: This switch must be in the
"on" position before the heater will operate.
Models
Description
400W Panel heater with
Electronic thermostat &
Timer
800W Panel heater with
Electronic thermostat &
Timer
800W Panel heater with
Electronic thermostat &
Timer-Black
400W Panel heater
with Electro mechanical
thermostat
800W Panel heater
with Electro mechanical
thermostat
OBJECTS OR CLOTHING
maintain the background
being higher than the
Models with Timer– DXLWP400TiE7,
DXLWP800TiE7 & DXLWP800TiE7B
DXLWP400TiE7 - 1 Switch
The switch on the side of the heater turns the
heater on. Note: This switch must be in the "on"
position before the heater will operate.
DXLWP800TiE7 & DXLWP800TiE7B - 2 Switches
The two switches on the side of the heater control
the amount of heat available as described below,
NOTE: At least one switch must be in the 'On'
position before the heater will operate.
Position O - OFF
Position I - ON
Both switches in Position I indicates maximum output.
Top switch only in Position I indicates 500W output
on 800W model.
Bottom switch only in Position I indicates 300W
output on 800W model
Control Description - Timer Models
Timer unit
The heating device is equipped with a configurable
electronic control, consisting of a display, a red LED
and five keys.
The control unit is located on the front panel of the
heater.
The set functions and values are shown on the
display.
The LED lights up red when heating ON.
Manual operation
Program no. (1 - 4)
Weekday
Setting the time
Heating operation off
Heating operation on
Key lock
P
MANUAL
ON
OFF
AUTO
COPY
Copy
Advance
Automatic operation
Time block off
Time block on
P
MANUAL
DLY
ON
OFF
BLK
COPY
Save entry
Select operating mode
Set program
Value down/up
M
T
ON OFF
W
T
F
S
S
ADVANCE
M
T
ON
OFF
W
T
F
S
AUTO
S
ADVANCE