Page 2
P a g e Salcom Product Documentation This document is designed to familiarise you with Salcom products and guide you through the hardware, configuration, installation and overall system management. Salcom is an environmentally conscious company and in an effort to conserve paper no longer prints manuals with shipped products.
P a g e Warranty and Disclaimer Salcom products are warranted for a period of 12 months from the date of purchase against faulty materials and workmanship. Should any fault occur the unit should be returned to the vendor, freight pre-paid. Please include a description of the fault to assist with prompt return.
0150 VHF Model has a variant with internal aerial, the 11-85-1150. Note: The 11-85 should not be used for industrial machinery control where a fail-safe mode of operation is essential. Contact Salcom for advice if this is a requirement. 11-85-0000 VHF & UHF POCKET PAGING TRANSMITTER...
Wire connections can be made to the internal connectors, and the wires can pass through the battery access hole, or provision for a hole can be made in the side of the case. 11-85-0000 VHF & UHF POCKET PAGING TRANSMITTER Product Manual...
• Some pager receivers do not respond as well as fixed receivers with external aerials 11-85-0000 VHF & UHF POCKET PAGING TRANSMITTER Product Manual Sea Air and land Communications Ltd, 10 Vanadium Place, Addington, Christchurch 8024, New Zealand...
Page 7
‘Tone Only’. A function level will control the number of beeps on the receiver (four different function levels can be sent). 11-85-0000 VHF & UHF POCKET PAGING TRANSMITTER Product Manual Sea Air and land Communications Ltd, 10 Vanadium Place, Addington, Christchurch 8024, New Zealand...
Page 8
Using the RS232 Serial Commands Serial commands can be “manually” issued to an 11-85SE from a PC via a Salcom 11-46 Programming Adaptor cable using a terminal program such as PROCOMM or Hyperterminal.
Page 9
(1200 baud) Usage cn<pager#>[<space>]<level>[<space>]<message><CR> Description Call numeric pager Example cn1234567 1 777<CR> Response Page Sent<CR> 11-85-0000 VHF & UHF POCKET PAGING TRANSMITTER Product Manual Sea Air and land Communications Ltd, 10 Vanadium Place, Addington, Christchurch 8024, New Zealand January 2018...
Page 10
You entered a valid command with invalid values ER6 BUSY 11-85SE is too busy to process the entered command, try again later. 11-85-0000 VHF & UHF POCKET PAGING TRANSMITTER Product Manual Sea Air and land Communications Ltd, 10 Vanadium Place, Addington, Christchurch 8024, New Zealand...
The internal 9-volt battery can be accessed by sliding back the battery cover on the rear of the unit. Recommended Battery: PP3, N1604 or 6F22 – 9-volt Alkaline 11-85-0000 VHF & UHF POCKET PAGING TRANSMITTER Product Manual Sea Air and land Communications Ltd, 10 Vanadium Place, Addington, Christchurch 8024, New Zealand...
Page 12
3 beeps at the beginning of a Voltage Controlled Oscillator (VCO) out of lock transmission 11-85-0000 VHF & UHF POCKET PAGING TRANSMITTER Product Manual Sea Air and land Communications Ltd, 10 Vanadium Place, Addington, Christchurch 8024, New Zealand January 2018...
Page 13
The 11-85SE can be programmed using the 11-85SESE (not Multi PSD) support software available free of charge from the “Support” section of our web site (www.salcom.com). The PSD software allows the user to configure input actions, POCSAG and transmission settings, pre-defined messages, and RF frequency.
Page 14
Message: User message, up to 40 characters in length. 11-85-0000 VHF & UHF POCKET PAGING TRANSMITTER Product Manual Sea Air and land Communications Ltd, 10 Vanadium Place, Addington, Christchurch 8024, New Zealand...
Page 15
Channel Spacing: Defines the frequency step resolution. Sent Response: Controls the serial response when a page has been transmitted. 11-85-0000 VHF & UHF POCKET PAGING TRANSMITTER Product Manual Sea Air and land Communications Ltd, 10 Vanadium Place, Addington, Christchurch 8024, New Zealand...
Page 16
P a g e | 15 Historically “Page Sent” would be sent by Salcom products to the serial port to provide a controlling application with feedback that another message may be submitted for transmission. Since the 11-85SE may queue many messages “Page Sent” may not describe sufficiently which page has been transmitted.
In this operational mode, the red LED briefly flashes once every second indicating that the unit is active. 11-85-0000 VHF & UHF POCKET PAGING TRANSMITTER Product Manual Sea Air and land Communications Ltd, 10 Vanadium Place, Addington, Christchurch 8024, New Zealand...
Page 18
| 17 Connection to 11-85SE Serial Port To send a paging message to the 11-85SE using a serial port a Salcom 11-46 programming adaptor cable must be used. The following lines from the PC or serial device serial port must be connected: The 11-85SE serial port will only be available if RTS and DTR are set.
Page 19
4 Button Model Button Action External Input Action Single Button Model Button Action External Input Action 11-85-0000 VHF & UHF POCKET PAGING TRANSMITTER Product Manual Sea Air and land Communications Ltd, 10 Vanadium Place, Addington, Christchurch 8024, New Zealand January 2018...
P a g e | 19 Technical Specification Technical Specification 11-85-0000 – VHF / UHF Hand Held Transmitter Frequency Range 148 - 164MHz - VHF (Model No. 11-85-0150 / 11-85-1150) 445 - 465MHz - UHF (Model No. 11-85-0450) Frequency Selection...
Page 21
- FCC CFR47 Part 90 (RF) - EN 301 489-2 V2.1.0 (EMC - EN 60950-1:2006 (Safety) 11-85-0000 VHF & UHF POCKET PAGING TRANSMITTER Product Manual Sea Air and land Communications Ltd, 10 Vanadium Place, Addington, Christchurch 8024, New Zealand January 2018...
Page 22
10 Vanadium Place Addington Christchurch 8024 New Zealand +64 (0)3 379 2298 W: www.salcom.com support@salcom.com 11-85-0000 VHF & UHF POCKET PAGING TRANSMITTER Product Manual Sea Air and land Communications Ltd, 10 Vanadium Place, Addington, Christchurch 8024, New Zealand January 2018...
Need help?
Do you have a question about the 11-85-0000 and is the answer not in the manual?
Questions and answers