Triax IFA288 Manual page 3

Introduction
Use
Approvals
Cleaning
Location
Safety
NOTE:
Connection to
the grid
EN
Please read this quick guide thoroughly before installing your new indoor
cable television distribution amplifier.
The amplifier is for use by consumers who have cable TV or a private an-
tenna connection, where there is a need to distribute the signal to several
rooms / connection sockets or to amplify the signal. The two variants, IFA
284 and IFA 288 can distribute TV/radio signals to 4 and 8 TV sets and/or
radios, respectively
The amplifier is approved for use with YouSee Ready and Stofa Approved
installations, and supports radio, TV and internet via cable television distri-
bution, from all sockets.
The amplifier can be wiped down with a dry or slightly damp cloth, but
should not be exposed to direct water or moisture.
The amplifier should be fastened securely with screws on a non-combus-
tible wall via the two middle screw-holes on either side of the base unit.
Please remove the cover to access.
Find a suitable location to position the amplifier. We recommend plac-
ing it in the immediate vicinity of the first antenna outlet in your house/
apartment and near apower outlet. We suggest installing approx. 120 mm
above the floor ( optional).
BOTH the amplifier and any cable modem in your installation MUST
be TURNED OFF during the entire installation. Also refer to section 6.
NOTE: If the amplifier is placed further away from an electrical outlet
than the fixed cord is able to reach, use an approved network extension
cord or let a qualified electrician connect the power. TV can be watched
once the installation of the amplifier is completed, connected to the
mains and turned on.
3