Advertisement
TO START AND STOP TOOL
1.
Confirm that the trigger switch is "OFF". Make sure that the power circuit voltage is the same
as that shown on the specification plate of the tool. Connect the tool to the power source.
2.
Squeeze the trigger switch (A) Fig. 1 to start the motor. Release the trigger switch to stop the
motor.
3.
A switch-lock button (B) Fig. 1 is provided to keep the motor running without holding the
trigger switch "ON".
A.
To LOCK the tool in the "ON" position, squeeze the trigger switch, push in and hold the
lock button while releasing the trigger switch.
B.
To RELEASE the switch-lock button, squeeze the trigger switch and release.
NOTE: The switch-lock button can be engaged only when the drill is running at maximum speed.
Never use the switch-lock button when the tool may have to be stopped
suddenly.
4.
This tool will operate in either the forward direction (clockwise rotation), or the reverse direction
(counter-clockwise rotation). ALWAYS allow the motor to completely stop before reversing the
direction. For CLOCKWISE rotation, move the switch button (C) Fig. 1 to the right. For COUNTER-
CLOCKWISE rotation, move the switch button to the left.
5.
VARIABLE SPEED: As the trigger switch is squeezed, the drill speed increases.
CHANGE BIT HOLDER
DISCONNECT TOOL FROM POWER SOURCE.
1.
Pull the Depth Stop Assembly (A) Fig. 2 from the clutch housing.
2.
Pull the bit holder (C) Fig. 3 out. If it is difficult to remove, grip it with pliers and pull.
NOTE: Bit (D) Fig. 3 may be removed from the bit holder by pulling it straight out.
3.
Push new bit holder into the spindle and snap it into place.
4.
Replace the Depth Stop Assembly (A) Fig. 2 and adjust the depth stop (see "ADJUST
DEPTH STOP").
ADJUST DEPTH STOP
1
.
Turn the adjusting collar until the end of the bit extends 3/32" beyond the end of the depth
stop. Do not push the bit holder in. This will engage the internal drive.
2.
Drive a test fastener in a piece of scrap material identical to that to be used. Examine the
results of the drive and make additional depth stop adjustments:
a)
To increase the depth of drive, repeat STEP 1 and turn the adjusting collar so that the
end of the bit extends further than the end of the depth stop.
b)
To decrease depth of drive, repeat STEP 1 and turn the adjusting collar so that the end
of the bit is closer to the end of depth stop. Each click of the adjusting collar results in
.007" change in the depth of drive.
3.
Repeat STEPS 1 and 2 until the desired result is obtained.
DRIVING DRYWALL SCREWS
NOTE: Maximum size screw for use with this tool is #12 Wood Screw.
1.
Install a drywall bit and bit holder in the screwdriver.
2.
Set the screwdriver for the correct rotation.
3.
Start the screwdriver and place a drywall screw on the bit.
OPERATING INSTRUCTIONS
2
Advertisement
