Download Print this page
NUTRICHEF PKBRTP50 Operation Instructions

NUTRICHEF PKBRTP50 Operation Instructions

Homebrew mini keg system

Advertisement

Quick Links

Mini Keg System
PKBRTP50
PKBRTP100
UNIT OPERATION INSTRUCTIONS
1. Spear Body
8. Faucet Knob
2. Cross-bar
9. Regulator
3. Twist Tube
10. Regulator Base
4. Pressure Relieving Ring
11. Regulator Knob
5. Nut
12. Gauge
6. White Flow-control Block
13. 16g C02 Capsule
7. Faucet
14. Beer Hose
PART ONE: SPEAR ASSEMBLY
1. Please clean mini-keg, cap, spear body, faucet and beer
hose with warm water and mild soap before use.
2. Insert white ow-control block into cross-bar, it would
limit the beer ow and reduce over-foam.
by
Homebrew
3. Install faucet into spear body, make sure the connection is
proper and tight.
Remark: Improper connection would cause leakage of beer.
4. Cut beer hose according to keg height and insert into
spear, make sure hose can touch bottom of keg without
overlong or over short.
Remark: If beer hose is too short, beer would not be tapped
completely. But if beer hose is too long, it may crimp inside
the keg, because of incomplete tapping.
5. Check whether the regulator knob is in OFF position.
If not, please follow arrow mark instruction to turn the
regulator knob counter clockwise to the OFF position.
2. Insert white ow-control block into cross-bar, it would
limit the beer ow and reduce over-foam.
6. Turn in a new 16g C02 capsule with thread type of 3/8"-24
UNF, turn clockwise rmly into the regulator base.
Important: DON'T stop turning if you hear a slight gas leak
swish, nish turning it in all the way it seal properly.
PART TWO: TAPPING
1. Attach the spear system to the
keg. Make sure they are as tight
as possible to avoid lessening
or leakaging.
2. Connect the regulator to the spear system
www.NutrichefKitchen.com
www.NutrichefKitchen.com

Advertisement

loading
Need help?

Need help?

Do you have a question about the PKBRTP50 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for NUTRICHEF PKBRTP50

  • Page 1 Important: DON'T stop turning if you hear a slight gas leak swish, nish turning it in all the way it seal properly. PART TWO: TAPPING PKBRTP50 PKBRTP100 1. Attach the spear system to the keg. Make sure they are as tight...
  • Page 2 Swish is expected if pressure If there is too much pressure, please pull on the pressure PKBRTP50 remains. 64 Oz Stainless Steel Complete Set Dispenser & CO2 System relieving ring for a couple of seconds.

This manual is also suitable for:

Pkbrtp100