Audio Loop Back; To Host - Yamaha SHS-500 Reference Manual

How to Use the Terminals

Audio Loop Back

You can set whether Audio sound input from the [TO HOST] terminal is returned to the smart device
or the computer or not with the performance played on the instrument by setting the Function
"Audio Loop Back" (page
played on this instrument to the smart device or the computer, set this parameter to off.
NOTICE
If you are using a DAW (digital audio workstation) with this instrument, set Audio Loop Back
to OFF. Otherwise, a loud sound may occur, depending on the settings of the computer or the application
software.
Precautions when using the [TO HOST] terminal
When connecting the computer to the [TO HOST] terminal, make sure to observe the following
points to avoid freezing the computer and corrupting or losing the data.
NOTICE
• Use an AB type USB cable of less than 3 meters. USB 3.0 cables cannot be used.
• Execute the following before turning the power to the instrument on/off or plugging/
unplugging the USB cable to/from the [TO HOST] terminal.
• Quit any open application software on the computer.
• Make sure that data is not being transmitted from the instrument. (Data is transmitted only
by playing notes on the keyboard or playing back a song.)
• While the computer is connected to the instrument, you should wait for six seconds or more
between these operations: (1) when turning the power of the instrument off then on again,
or (2) when alternately connecting/disconnecting the USB cable.
If the computer or the instrument freezes, restart the application software or the computer OS,
or turn the power to the instrument off then on again.
5). The default setting is on. If you want to output only the sound

TO HOST

SHS-500
12
Audio data
Return with the keyboard
performance
Smart
device
(page 5)