Advertisement
Quick Links
Installation
Branches requires a -12V /
+12V power supply (2x5 pin
connector). The ribbon cable
connector must be aligned
so that the red stripe of the
ribbon cable (-12V) is on the
same side of the module's
power header as the "Red
stripe" marking on the board.
The power consumption is:
+12V: 10 mA; -12V: 1 mA.
The trigger/gate signals
Branches
generated by Branches
have a +5V level.
Dual Bernoulli gate
Online manual and help
The full manual can be found
online at:
mutable-instruments.net/mod-
ules/branches/manual
For help and discussions, head to:
mutable-instruments.net/forum
Please refer to the online manual
for detailed information regarding
compliance with EMC directives
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Mutable Instruments Branches
Summary of Contents for Mutable Instruments Branches
- Page 1 Installation Branches requires a -12V / +12V power supply (2x5 pin connector). The ribbon cable connector must be aligned so that the red stripe of the ribbon cable (-12V) is on the same side of the module’s power header as the “Red stripe”...
- Page 2 Branches consists of two In extreme settings, the out- identical sections called come is no longer random – Bernoulli gates. An internal causing the module to behave connection routes the input of like a voltage-controlled section 1 to section 2 – unless switch.
Need help?
Do you have a question about the Branches and is the answer not in the manual?
Questions and answers