Download Print this page

Mutable Instruments GRIDS User Manual

Topographic drum sequencer

Advertisement

Quick Links

Advanced settings
1s
Unplug all CV inputs and hold the TAP (reset) button for
a second to adjust Grids' settings. Refer to the diagram
on the next pages for a list of all available settings. The
3 LEDs indicate the value of the setting being modifi ed.
Hold the TAP (reset) button again for a second when you
are done.
Online manual and help
The full manual can be found online at
mutable-instruments.net/modules/grids/manual
For help and discussions, head to
mutable-instruments.net/forum/
Please refer to the online manual for detailed infor-
mation regarding compliance with EMC directives
Advanced settings diagram
Sequencer mode
Grids can also work as a plain
euclidean sequencer.
Grids is yet another
euclidean sequencer
Grids is back to
drumming duties
When euclidean sequencer mode is
enabled, the MAP X / Y / CHAOS knobs
have alternate functions, (STEPS 1-3) as
shown in red on the panel – they control
the duration (number of steps) of the
sequence; while the FILL knobs control
the fi ll rate.
Trig / Gate output
Outputs are 1 ms triggers
Outputs are gates
Clock resolution
4ppqn
8ppqn
24ppqn
Tap button function
Tap to restart at the beginning
of the sequence
Tap to set the tempo
Chaos knob function
STEPS 1
Pattern randomness amount
Internal clock swing
STEPS 2
Outputs confi guration
Grids can output either: three individu-
al accent tracks (one per instrument);
STEPS 3
or a global accent track, a clock signal
(received on the clock input or internal,
whichever is used), and a reset trigger
sent at the beginning of the pattern.
ACC 1 / ACC 2 / ACC 3
ACC / CLK / RST
Grids
Topographic drum sequencer

Advertisement

loading

Summary of Contents for Mutable Instruments GRIDS

  • Page 1 Unplug all CV inputs and hold the TAP (reset) button for Topographic drum sequencer enabled, the MAP X / Y / CHAOS knobs a second to adjust Grids' settings. Refer to the diagram have alternate functions, (STEPS 1-3) as Chaos knob function on the next pages for a list of all available settings.
  • Page 2: Front Panel

    Installation Front panel Synthesizing Map X Grids requires a -12V / +12V power supply (2x5 pin Controls connector). The ribbon cable connector must be aligned Tempo, from 40 to 240 BPM. When turned fully so that the red stripe of the ribbon cable (-12V) is on the counter-clockwise, the internal clock stops and the same side of the module’s power header as the “Red...