Important Information; Important Information Concerning Road Safety; Important Information Concerning Installation - Porsche Classic Installation Instructions Manual

Important information

Important information concerning
road safety
The PCRN (Porsche Classic Radio Navigation
System) is the central control centre for radio,
media functions, iPod, external audio sources,
sound settings, navigation system and Bluetooth
telephony. In order to avoid any risk to yourself and
other road users when using your PCRN, please
make sure to observe the following points:
Risk of accident! Any distraction may lead to
a loss of control over your vehicle.
Only operate the controls of your PCRN when
 
it is safe to do so and when traffic permits.
If you have any doubt, stop and use the PCRN
when the vehicle is at standstill.
Risk of accident! The navigation system
assists the driver by suggesting a route. It is
still your sole responsibility as the driver to
drive safely and to observe and comply with
all laws and legal requirements pertaining to
road safety.

Installation instructions
It is your obligation as the driver to be aware
of the traffic situation at all times. You as
the driver are solely responsible for the safe
operation of your vehicle.
Always be aware of the traffic situation.

Important information concerning
installation
This device was designed for use in vehicles
with a 12 volt battery. Before you install the
radio device in your vehicle, make sure that the
battery voltage conforms to the radio device. If
this is not the case, use a voltage transformer to
convert the supply voltage to 12 volt.
Risk of short circuit and fire when working on

vehicle electrical systems. Disconnect the
battery when working on vehicle electrical
systems.
To prevent short circuits in the cabling and

damage to the device, secure all cables with
cable clamps or insulating tape. Do not run
cables past places that heat up. To ensure
that the cable insulation remains intact, also
avoid places with moving parts, such as the
gear lever, handbrake lever or seat rails.
To prevent short circuits and damage, do not

route cables through the engine compartment
to connect to the battery.
If the fuse is detective, replace it only with a

new 15 ampere fuse. Never use a fuse other
than that stated, since this can cause cable
fires or short circuits.
Never connect devices to the battery, since

this can cause the battery to overheat.
Ensure that all cable connections to the

loudspeakers are properly insulatedin order to
prevent short circuits.
Avoid connections from the earth cable to the

loudspeaker output, as this can damage the
internal power amplifier.
The maximum load of the used loudspeaker

is 4 x 45 watt.
Make sure the loudspeaker is correctly con-

nected, since the navigation announcements
are routed only to the front loudspeakers.
In principle, no tachometer signal is required

for the functionality of the device.
We recommend that the device is installed at

a specialist workshop.
Vehicles with antenna amplifiers must connect
the ISO plug (black) to PIN5 (blue). If you have
any questions, please contact your Porsche
Centre.