Air Operation; Trigger (Channel Setup); Remote Control (Group Setup) - Profoto B10 User Manual

Air operation

Trigger (Channel setup)

The Profoto B10 has AirTTL built-in which means it can be wirelessly
triggered and remote controlled from any Profoto Air remote or from
the Profoto A1. The Profoto B10 also fully supports AirTTL and High
Speed Sync if this is supported by your Air remote and/or camera. The
basic trigger setup is very easy in three simple steps and requires no
linking between units.
1. Activate Air on the Profoto B10 by selecting AIR ON in the Settings
menu.
2. Turn on your Air Remote.
3. Select the same AIR CHANNEL (1-8) on your Air Remote and on
your Profoto B10.
NOTE
All flashes on the same AIR CHANNEL will always trigger together, regardless of AIR
GROUP setting.

Remote control (Group setup)

Remote controlling the Profoto B10 from an Air Remote or a Profoto A1
is almost as easy as triggering and requires no linking between units.
1. Perform the CHANNEL setup.
2. Select AIR GROUP (A-F) on the Profoto B10.
3. Select the same GROUP on your AIR remote.
NOTE
If you are using more than one light off camera you can set them into different groups
to enable individual remote control. For detailed operating instructions, check the user
guide for your Air Remote or Profoto A1.
www.profoto.com
25