Continuous Light; Advanced Settings - Profoto B10 User Manual

Continuous light

The CONTINUOUS LIGHT setting defines how the continuous light
intensity is adjusted. There are two selectable settings, PROP and
FREE. Factory default setting is FREE.
•
PROP: The continuous light intensity is always proportional to the
flash power setting. This setting is recommended if the continuous
light is used as modeling light.
•
FREE: The continuous light intensity can be set independent
from the flash power setting. This setting is recommended if the
22
continuous light is used as video light.
NOTE
For instructions on how to adjust the continuous light when either PROP or FREE is
selected, go to the section "Adjust the continuous light".

Advanced settings

Ready signal
The READY SIGNAL setting sets how the Profoto B10 indicates that it
is fully recycled after a flash and is ready to flash again. There are four
selectable settings:
•
SOUND: The Profoto B10 beeps when it has recycled and is ready
to flash.
•
DIM: The continuous light turns off after flashing and turns on when
the Profoto B10 has recycled and is ready to flash.
•
SOUND & DIM: The Profoto B10 signals with both SOUND and
DIM.
•
OFF: The Profoto B10 doesn´t signal that it is ready to flash. This is
the factory default setting.
NOTE
The test button [12] always comes off after flashing and comes on again when the
Profoto B10 is fully recycled. The Profoto B10 will always flash even when not fully
recycled but the flash power might then be lower than the set flash power.
www.profoto.com