Winding The Bobbin - Baby Lock Joy BL25B Instruction And Reference Manual

q
w
q
z
w
x
e
c
v
b
(A)
(B)

Winding the Bobbin

Setting the spool
Place a spool of thread on the spool pin with the thread
coming off the spool as illustrated.
A: Press the large spool holder firmly against the spool of
thread.
q Large spool holder
B: For a small spool, use the small spool holder.
w Small spool holder
z Hold the thread with both hands and pass the thread
under the thread guide.
Guide the thread around the bobbin winding thread
guide.
q Thread guide
w Bobbin winding thread guide
x Pass the thread through the hole in the bobbin from
the inside to the outside.
Put the bobbin on the bobbin winder spindle.
e Bobbin winder spindle
c Push the bobbin winder spindle to the right.
v Hold the free end of the thread in your hand and start
the machine.
Stop the machine when the bobbin has been wound a
few layers, and cut the thread close to the bobbin.
b Start the machine again. When the bobbin is fully
wound, it will stop automatically.
Stop the machine and return the bobbin winder spindle
to its original position by moving it to the left, and cut
the thread with a pair of scissors. Remove the bobbin
from the bobbin winder spindle.
NOTE:
The machine will not sew until the spindle has been
returned to the left.
20