Advertisement
Vermont Castings Seville Insert
2. Install the Floor Protector
Make sure the floor protector satisfies the requirements
discussed on Page 7.
3. Assemble the Surround Panel
Installation will include:
(1) Surround panel, Top
(1) Surround panel, Left
(1) Surround panel, Right
(2) Mounting brackets
(2) 1/4-20 x 1" Flat head phillips screws
(2) 1/4-20 x 3/4" Hex head screws
(4) 1/4-20 x 1/2" hex head screws
(6) 1/4" Flat washers
(1) 3/8" diameter, plug button
(2) Damper tabs
(2) 1/4-20 x 1/2" Round head screws
(1) Brass rod
(1) 1/4-20 Nut
(1) Thermostat rod
(1) Brass ball
f i r e - p a r t s . c o m
Tools required: Phillips head screwdriver and 7/16"
wrench or socket
Rear View
Washer
Hex Head Screw
Damper
Tab
Rod, Front,
Gold Plate
Fl Hd, Ph
1/4-20 x 1³⁄₄"
Bracket,
Surround Mount
Sourround Right
1/4-20 Nut
Fig. 7 Surround parts.
1. Begin by preparing the stove insert to receive the
surround assembly by attaching the mounting brackets
to the insert. (Fig. 8) Locate the mounting brackets
over the threaded holes with the bracket clevis pointing
towards the rear of the stove. Fasten with 1/4-20 x 3/4"
hex head screws with flat washers. Repeat this pro-
cess on both sides of stove.
8
Surround Top
Sorround
Plug Button
Thermostat
Rod
Brass Ball
FP1155
2. Insert the longer threaded end of the thermostat rod
into the control lever located on the left side of the
Seville Insert and through the 1/4-20 nut. (Fig. 8 & 9)
Tighten nut against the lever using a 7/16" wrench.
Surround Bracket
Fig. 8 Attach surround bracket and thermostat rod to side of
Seville Insert.
1/4-20 Nut
Left
Fig. 9 Thermostat rod assembly.
3. Assemble the brass rod to the surround top by
placing the surround top section face down on a soft
surface such as carpeting. Place the brass rod in the
two indentations. Place a damper tab over each
indentation capturing the rod. Align the clearance hole
in each tab with the threaded hole next to the indenta-
tions. Secure the tabs with 1/4-20 x 1/2" round head
screws.
4. With the surround top still face down, attach the left
side panel. Align the two clearance holes in the side
panel with the two threaded holes in top section.
Fasten together using the 1/4-20 x 1/2" hex head
screws and washers. Provide support to the surround
top to assure proper alignment. Repeat this process for
the right side panel.
Control Lever
Thermostat
Rod
Control Lever
Thermostat Rod
30001586
KT271
KT268
Advertisement
