Status Light; Mount The Status Light On Your Computer; Do-Not-Disturb Mode - Philips SpeechOne PSM6300 User Manual

Status light

Use the status light in order to indicate to your
colleagues if you are available or busy. This way, you
can work more productively due to less interruptions.

Mount the status light on your computer

1
Turn the status light into the starting position as
displayed in the illustration below . Then hold it at the
bottom part and pull the upper part in your direction
until it reaches a horizontal position.
2
Connect the docking station to your computer via the
supplied USB cable. Make sure you use the USB port
for PC connection marked with
station. Then connect the status light to the status
light port on the docking station.
3
Remove the sticker from the magnet on the bottom of
the status light.
16 Use your SpeechOne
on the docking
4
Mount the status light either on the side or on the
back of your screen.

Do-not-disturb mode

While you are recording with your SpeechOne, the LED
of the Do-not-disturb button on the docking station and
the status light automatically glow red indicating that
you are not available.
However, you can also activate the Do-not-disturb
mode whenever you would like to indicate that you are
busy.
To turn the Do-not-disturb mode on:
• Press the Do-no-disturb button on the docking station
once.
X The LED of the Do-not-disturb button on the
docking station and the status light glow red.
To turn the Do-not-disturb mode off:
• Press the Do-not-disturb button on the docking
station again.
X The LED of the Do-not-disturb button on the
docking station turns off and the status light glows
green.
Note
• If you receive a Skype call while you are in a recording
session and you accept the call, the status light and
the LED of the Do-not-disturb button keep glowing
red.