Advertisement
Trouble Shooting
AFTER INSTALLATION, THE BATTERY
PROG
BRAIN DOESN'T SEEM TO
BE WORKING.
WHAT TO DO
1. Be sure your battery is holding the proper
charge.
2. Make sure the positive side of the Battery
Prog Brain (the printed side) is attached to the
positive (+) post of the battery.
3. Check that the Manual Reset Control Knob is
pointing to the "ON" position.
4. Check that the black ground wire is securely
attached to the negative (-) post on the battery.
AFTER THE BATTERY PROG BRAIN HAS
DISCONNECTED POWER,
THE REMOTE CONTROL DOES NOT RESET
THE POWER.
WHAT TO DO
1. Make sure that the light on the Remote
Control is lit when you press the button
down. If the light does not come on, open the
Remote Control and replace
the battery.
2. Hold the Remote Control button down for five
seconds to activate Battery Prog Brain.
3. Turn the Manual Reset Control Knob to
"ON".
4. Check that the black ground wire is securely
attached to the negative (-) post on the battery.
BATTERY PROG BRAIN IS FREQUENTLY
DISCONNECTING POWER FOR
NO APPARENT REASON.
WHAT TO DO
1. Your car battery may be low in power due to
Alternator function.
If it cannot hold a charge, it may be at the end
of its life cycle.
2. The electrical system might have an
unknown short. Consult a certified technician.
3. Make sure all lights are off.
4. Disconnect all accessory electronics (radio,
phone charger, DVD player, etc.) and check
again.
YOU CANNOT DETERMINE A BATTERY
PROG BRAIN INSTALLATION CONFIGURATION
FOR YOUR VEHICLE OR LOCATE BATTERY
CONNECTIONS.
WHAT TO DO
1. Consult a certified technician.
IMPORTANT NOTE:
If a warning light for NO CHARGE or BATTERY
WARNING illuminates on your dashboard, stop
your vehicle at a safe area and TURN THE
MANUAL RESET
CONTROL KNOB (located under the
removable protective cover on the Battery Prog
Brain unit itself) TO THE "OFF" POSITION. Your
vehicle will experience a complete loss of
power unless the "No Charge" problem is
repaired immediately! This problem is unrelated
to the Battery Prog Brain and requires assistance
from a qualified technician.
Advertisement
