Advertisement
Quick Links
"Battery Prog Brain" the programmable ERD unit.
This unit has the ERD feature (Engine Running Detection).
Then detecting electronic noises the BPB will be in a standby mode, it will
not disconnect the power even when the battery energy is lower than the
disconnecting threshold.
IMPORTANT NOTE: After installation, test the ERD function to make sure
your vehicle electronic noises are detected, if not then you need to
connect the "engine on" wire (see "Engine On" wire instructions)
What is the "Battery Paog Brain" (BPB)
Battery Prog Brain is an innovative accessory that easily installs to any battery.
Using unique micro-electronic technology it continually monitors the
battery power. When Battery Prog Brain detects power falling below the
threshold level required to start your engine, it automatically isolates the
battery from the electrical system. This will ensure the battery always have
enough power to start your engine and will prolong the battery life. There
are a few ways to reset the power according to the type of BPB you have
purchase.
*Type III & IV (Gold) have the ability to disconnect the battery from the
electrical system intentionally and to act as an anti-theft device.
*Type IV RV (Utility) is designed to extend battery life by protecting
utility/house/coach batteries rather than the vehicle starting battery and
can disconnect the battery from the electrical system intentionally to
preserve battery power when not in use.
Advertisement
Summary of Contents for BPB Battery Prog Brain
- Page 1 This will ensure the battery always have enough power to start your engine and will prolong the battery life. There are a few ways to reset the power according to the type of BPB you have purchase.
-
Page 2: Current Specifications
If your battery does not hold a minimum charge (over 12V) it may be at the end Battery Prog Brain 220 gm, Accessories 210 gm, of its lifecycle. The Battery Prog Brain is designed to Packaging 145 gm; protect a properly functioning battery. It cannot Total weight 575gm (1.3lb). - Page 3 1. Manual “ON/OFF” Reset Control Knob under removable protective cap 2. Positive (+) side of Battery Prog Brain (side with writing) with Butterfly Connector 3. Black Ground Wire, attached to unit 4. White Antenna Wire, attached to unit (type II &...
- Page 4 NOTE: Battery location and position differ in (Type II) & Gold-Remote/Anti-theft (Type III) vehicles. With the supplied accessories you can Models Only) mount the Battery Prog Brain on the vehicle using the Top Mount, Side Mount or Chassis Mount Remote Control Frequency: TX433.92 Mhz positions.
- Page 6 A fuse tap connection may be engine on wire onto the single connector required. on the Battery Prog Brain that is labeled with “ACC”. C) Carefully route the wire from the fuse to the Battery Prog Brain. A fuse-tap or C) Attach the other end of the supplied wire-tap connection may be required.
- Page 7 Alternator, ECM or any accessory device that requires electrical power. Installation Tip: Remote Location: If you wish to mount the Battery Prog Brain in a remote location due to space limitations, or if desired, use proper battery cable. (Additional cable not supplied) Series configuration options shown for example purposes only.
- Page 8 If not, review the installation instruction or Prog Brain Type III and the wired remote button consult a certified technician. supplied with the Battery Prog Brain IV can be used to disconnect and reconnect power by choice BATTERY PROG BRAIN (as an anti-theft device), as well as reestablish- ing power after draining.
-
Page 9: Troubleshooting
THE POWER. repaired immediately! This problem is unrelated WHAT TO DO to the Battery Prog Brain and requires assistance 1. Make sure that the light on the Remote from a qualified technician. Control is lit when you press the button down. - Page 10 Step 4: Connect the BPB with the positive (+) side to the positive pole of the battery Step 5: Connect the Red cable to the “out” side of the BPB using the accessory needed.