Allen-Bradley 1585BP Installation Instructions

Using a cable stripper,
3
remove approximately
38 mm (1.5 in.) of sheath-
ing.
Place modular plug
7
over wire ends being
sure to maintain color code.
Insure that the pairs are in-
serted all the way into the
modular plug including the
inner jacket. The inner jack-
et should be directly under
the plug's strain relief tab.
Installation Instructions
Bulletin 1585BP UTP Plug
IMPORTANT: SAVE THESE INSTRUCTIONS FOR FUTURE USE.
Refer to the product catalog pages for additional information.
Cut the rip cord as
4
close to the jacket as
possible. Fan pairs into
proper color code (see next
frame).
Using a crimp tool
8
(1585A--JCRIMP),
terminate the modular
plug to the cable.
Product includes: flex
1
nut, plug assembly,
and modular plug.
T568A
Color Code
Pair 2
Color Key:
Pair 3 Pair 1 Pair 4
1=White/Green
2=Green
3=White/Orange
4=Blue
1 2 3 4 5 6 7 8
5=White/Blue
6=Orange
7=White/Brown
8=Brown
T568B
5
Color Code
Pair 3
Color Key:
Pair 2 Pair 1 Pair 4
1=White/Orange
2=Orange
3=White/Green
4=Blue
1 2 3 4 5 6 7 8
5=White/Blue
6=Green
7=White/Brown
8=Brown
= Tip = Ring
Slide the plug housing
9
up the cable and align
with the modular plug.
1
Place plug housing
2
over the industrial
cable as shown, flex nut
may need to be loosened.
Note: Outer cable
diameter range 4 8 mm
...
(0.160 0.315 in.)
...
After fanning pairs to
6
proper color code,
hold the pairs close to the
jacket and trim conductors
leaving 12 mm (0.5 in.) ex-
tending from the inner jack-
et.
12 mm
(0.5 in.)
Insert the modular
10
plug into the plug
housing. Align the latch with
the LATCH slot, depress
latch and insert plug into
plug housing until it bottoms
out.