IOtech 640u Quick Start

IOtech 640u
USB2.0 Dynamic Signal Analyzers for Vibration Analysis & Monitoring

Step 1 - Install Software

1. Close all running applications on the host PC.
2. Insert the Dynamic Signal Analysis CD into your CD-ROM drive and wait for the CD to auto-run. An Opening
Screen will appear. As an alternative, you can download software from: www.iotech.com/ftp.html
3. Click the <ENTER SETUP> button.
Note: If you are downloading software from our website, follow instructions provided there.
4. From the hardware selection screen [which follows a licensing agreement], select the 640, 650 product-line
from the drop-down list and follow the on-screen instructions.

Step 2 - Connect the 640u or 650u to the Computer

1. Using a USB cable, connect the 640u [or 650u] to a USB2.0 port on the computer. USB2.0 port is required.
2. Follow the computer screen prompts as directed to allow the computer to detect your new hardware.
Note:
Power LED: The "Power" LED blinks during device detection and initialization; then remains on solid
as long as the module has power. If there is insufficient power the LED will go off.
Active LED: This LED is on whenever active communication is taking place between the 640 [or 650]
and the host PC. Note that the Active LED will be on solid during a data acquisition.
650u
&
Before you get started verify that you have a 32-bit version
of Windows, the following items, and meet or exceed the
minimum requirements listed.
• 640u or 650u
• USB Cable
• USB2.0 port
[on PC]
• Dynamic Signal Analysis CD
• License Keys for purchased software;
e.g., eZ-Analyst, eZ-TOMAS, eZ-Balance, eZ-NDT
•
Monitor: SVGA, 1024 x 768 screen resolution
• Windows 2000 SP4 and Windows XP users:
™
Intel Pentium 4 or equivalent
1 GB memory; 10 GB disk space
• Windows Vista (x86) users:
PC must be Windows Vista Premium Ready
Quick Start
324540C-01