1. Manuals
  2. Brands
  3. IOtech Manuals
  4. Measuring Instruments
  5. logbook/300
  6. Quick start manual

IOtech logbook/300 Quick Start Manual

Stand-alone, intelligent pc-based, data acquisition system
Hide thumbs
1
2
3
4
5
6
7
8
Table of Contents

Advertisement

Quick Links

Download this manual
QUICK START
LogBook/300
Stand-alone, Intelligent PC-based,
Data Acquisition System
IOtech
LogBook/300
25971 Cannon Road
461-0940 rev 3.0
Cleveland, OH 44146-1833
(440) 439-4091
Fax: (440) 439-4093
*324586C-01*
sales@iotech.com
productsupport@iotech.com
www.iotech.com
324586C-01

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the logbook/300 and is the answer not in the manual?

Questions and answers

Related Manuals for IOtech logbook/300

Summary of Contents for IOtech logbook/300

  • Page 1 QUICK START LogBook/300 Stand-alone, Intelligent PC-based, Data Acquisition System IOtech LogBook/300 25971 Cannon Road 461-0940 rev 3.0 Cleveland, OH 44146-1833 (440) 439-4091 Fax: (440) 439-4093 *324586C-01* sales@iotech.com productsupport@iotech.com www.iotech.com 324586C-01...

  • Page 2: Software Installation

    Failure to do so could result in electric shock or death, and equipment damage, even under low-voltage conditions. When using LogBook/300 in attached mode, the PC-Card [in LogBook/300] must already logbook.sys. have the file Otherwise, LogView cannot communicate with LogBook/300, and LogBook/300 will appear dead.
  • Page 3 Parallel port to parallel port – If using the parallel port, connect a DB25male to DB25female parallel cable [e.g., CA-35-2 or CA-35-6 (2ft. or 6ft. respectively)] to PARALLEL PORT on LogBook/300, and to the corresponding parallel port on the host PC. When this method is used, the PC must be set to the ECP mode.

  • Page 4: Hardware Configuration

    DBK Options Manual PDFs for information regarding these devices. Note that certain DBK options require manual configuration. LogBook/300's top cover does not need to be removed, except to add or remove an LBK option, or to replace the fuse.
  • Page 5 Close. The Close button may be used at any time to exit the LogBook Configuration applet. The second configuration window displays the properties for the selected LogBook/300. Fields include: LogBook/300 Quick Start Guide...
  • Page 6 The majority of today’s PCs support the Enhanced Computer Port protocol (ECP). If your computer does not support ECP, you can communicate with the LogBook/300 via the RS-232 serial port, or you can add an ECP-compatible ISA board or PC-Card parallel port. Setting the PC to ECP mode varies with different computers.
  • Page 7 (b) Make sure the communication cable (serial or parallel) is firmly in place to the proper ports. (c) Verify the device is powered-on. Testing the LogBook/300 device might cause the system to hang. If test results are not displayed within 30 seconds, or if the system does not respond properly do the following: Reboot the system.
  • Page 8 An acquisition is configured using LogView on a PC and then stored as an acquisition setup file on a PC-Card. The PC-Card may be in an attached LogBook/300 or in the PC to be later manually transferred to an unattached LogBook/300. The system’s DBK cards are listed; the scan sequence is defined; the trigger conditions are specified, etc.

Table of Contents