Connect The Psu And The Ethernet Cables; Configuration; Initial Access To The Usee Unit: Wireless Ethernet - HELVAR uSee Installation And Setup Manual

2.3. Connect the PSU and the Ethernet cables

+V −V
PSU
3.

Configuration

There are two methods of connecting to the uSee unit from a device running a web browser.
1. Wireless Ethernet: Connect to the uSee unit via wireless Ethernet.
For configuration instructions, see section 3.1, 'Initial access to the uSee unit: Wireless Ethernet', on this page.
Note: uSee generates an ad-hoc Wi-Fi network that may be incompatible with certain devices. If wireless access is still
required, you can connect a wireless access point (not supplied) to the uSee
2. Direct control: Operate the uSee unit directly, using a keyboard, a mouse and a monitor/display.
For configuration instructions, see section 3.2 on page 9.

3.1. Initial access to the uSee unit: Wireless Ethernet

Follow the steps below to configure the uSee Web Browser User Interface using wireless Ethernet to connect to the
web-browsing device.
Helvar 8801 uSee Web Browser User Interface: Installation and Set-Up Guide
4
SS
LAN 2 for
router network
COM
LAN 1 for local
computer network