Initial Access To The Usee Unit: Direct Control - HELVAR uSee Installation And Setup Manual

3.2. Initial access to the uSee unit: Direct control

Follow the steps below to operate the uSee unit directly, using a keyboard, a mouse and a monitor/display.
3.2.1. Connect a USB mouse and a USB keyboard to the uSee unit.
3.2.2. Connect a monitor/display to the uSee unit.
3.2.3. Configure the uSee unit's network settings
As soon as the uSee unit is powered on, it will display
the Helvar System Hub dialog box.
Note: Consult the network administrator for IP settings
compatible with your network.
1. Click Network Settings.
2. When the Network Settings dialog box is displayed,
type the IP address of the uSee unit.
3. Type the subnet mask, the gateway and the DNS
values.
4. Click Apply, and then click Close.
Note: The discovery of a workgroup and any further
setup of the uSee unit should be managed via the
Configuration section of its web interface (see
section 4 on page 10).
Helvar | Data is subject to change without notice.
SS
www.helvar.com 9