Edit The Network Settings - HELVAR uSee Installation And Setup Manual

6.2. Edit the network settings

1. On the Network Settings
screen, click the Edit
buttons, and then type the
Computer Connection
IP address (i.e. the IP
address of the uSee unit)
and the Lighting Router
Connection IP address
(i.e. the connection from
the uSee unit to the
lighting router).
Note 1: Consult the network administrator or commissioning engineer for IP settings compatible with your lighting router
network.
Note 2: After you change the network settings for the Lighting Router Connection, the uSee Web Browser User Interface
may take several minutes to see the workgroups on that Ethernet network. Go to the Workgroups page and
refresh your browser on a regular basis until the expected workgroup appears in the Workgroups list.
2. Make sure that the connection has been made: click the Workgroup Settings bar.
When the connection is made, the workgroup name will appear in the drop-down list on the Workgroup Settings
section of the Configuration Settings page.
3. Click Workgroups.
4. When the connection is made, the workgroup name will appear in the list: select it.
5. Click Minimal Discover or Complete Discovery.
6. Click Home to return to the uSee main screen.
7. You can now control the lighting system using uSee: context-sensitive help is available by clicking
the icons.
?
Helvar | Data is subject to change without notice.
www.helvar.com 15