How To Fit A Felt Wheel - NOCRY NRT-128AC Instruction Manual

5. Use the screwdriver end of the
wrench tighten the mandrel to secure
the disk firmly in place, so it does not
wobble. Do not over-tighten it to not
crack the disc!
Choose whether you'd like to use the collet nut or the adjustable chuck for
attaching the mandrel to your rotary tool, and set it up accordingly. The
instructions for attaching an accessory with the collet nut kit can be found on page
28, and the instructions on attaching an accessory using the adjustable chuck - on
page 30.
How to fit a felt wheel
1 Choose one of the white felt mandrels - notice the tiiiiiny little dent in the
middle of it? It's like a needle had gone through it. Take the felt wheel
mandrel, place the sharp point of it in that dent, and just screw the felt wheel
onto the mandrel until the screw part is fully inside the wheel.
2 Choose whether you'd like to use the collet nut or the adjustable chuck for
attaching the mandrel to your rotary tool, and set it up accordingly. The
instructions for attaching an accessory with the collet nut kit can be found on
page 28, and the instructions on attaching an accessory using the adjustable
chuck - on page 30.
32