Welding Symbols; N·m - Honda Accord 2008 Body Repair Manual

Main Menu
Installation
NOTE:

Welding symbols

●
: 2-Plate spot welding
: 3-Plate spot welding
: 4-Plate spot welding
: MIG plug welding
: MIG fillet or butt welding
L= Welding length Unit: mm (in.)
( ): The number of welds
●
1. Clamp the new damper housing, front wheelhouse,
wheelhouse upper inner, and front bulkhead, and
measure the front compartment diagonally.
2. Check the body dimensions.
Engine compartment (see page 4-3)
●
Engine/transmission mount position (see page 4-4)
●
Front wheelhouse lower member position (see
●
page 4-5)
Engine compartment and front floor under view
●
(see page 4-12)
Repair chart, top view (see page 4-14)
●
Repair chart, side view (see page 4-16)
●
3. Tack weld the new parts and front bulkhead into
position.
4. Temporarily install the front subframe, and check the
front side frame position.
5. Temporarily install the front fender, hood, and door,
then check for differences in level and clearance.
Check the external parts fitting position (see page
4-10). If necessary, check the headlight and front
bumper positions. Make sure the body lines flow
smoothly.
Table of Contents
6. Do the main welding.
Weld the damper housing (A), damper housing
●
lower extension (B) to the front side frame (C).
Weld the damper housing and dashboard upper
●
side member (D).
C
7. From the passenger's side, plug weld the holes in the
dashboard lower (A) and damper housing lower
extension (B).
A
(3)
A
B
(13)
D
(1)
(6)
B
(cont'd)
3-9