Honda Accord 2008 Body Repair Manual page 48

Main Menu
Front Wheelhouse/Damper Housing
Removal (cont'd)
Construction
Remove the wheelhouse upper member.
●
Replace the wheelhouse upper inner and lower member as an assembly, and check the wheelhouse lower member
●
support position for damage. If necessary, replace it.
Check the damper position for damage. If necessary, replace the front wheelhouse and damper housing.
●
DAMPER HOUSING
FRONT WHEELHOUSE
LOWER MEMBER SUPPORT
FRONT SIDE FRAME
3-8
Table of Contents
DAMPER HOUSING
FRONT WHEELHOUSE
6 x 1.0 mm
9.8 N·m
(1.0 kgf·m, 7.2 lbf·ft)
DASHBOARD UPPER
SIDE MEMBER
WHEELHOUSE
LOWER MEMBER
(A): Drill the positions shown in ［DETAIL Z］ from
the outside of dashboard upper member, and drill
the two spot welded points at the joint for the
wheelhouse upper inner and damper housing.
(B): Peel back the lower of dashboard upper side
member; drill the one spot welded point at the joint
for the wheelhouse upper inner and damper housing.
9 mm (0.35 in.)
12 mm (0.5 in.)
28 mm (1.1 in.)
WHEELHOUSE
UPPER MEMBER
45 mm (1.8 in.)
DASHBOARD UPPER
SIDE MEMBER
(A)
(A)
［DETAIL Z］
(B)
WHEELHOUSE
UPPER INNER