Lock (Parental Control); Rating; Password (Security Code); Area Code - Toshiba SD-26VESE Owner's Manual

Initial Settings - DVD (Continued)

LOCK (Parental Control)

DVD

Rating

Some movies contain scenes that may not be suitable
for children to view. Many of these discs contain
parental control information that applies to the complete
disc or to certain scenes on the disc. Movies and
scenes are rated from 1 to 8, depending on the area.
DVD video discs may or may not respond to the
parental control setting if the Area code of the disc is
set wrongly. Some discs offer more suitable scenes as
an alternative. Ratings are area dependent.
The parental control feature allows you to block access
to scenes below the rating you input, thereby preventing
your children from being able to view material you
believe is unsuitable.
1. Select "Rating" on the LOCK menu then
press B.
2. To access the Rating, Password and Area Code fea-
tures, you must input the 4-digit security code you
created.
If you have not yet entered a security code you are
prompted to do so. Input a 4-digit code and press
ENTER/OK. Enter it again and press ENTER/OK to
verify. If you make a mistake before pressing
ENTER/OK, press CLEAR.
3. Select a rating from 1 to 8 using the v / V buttons.
1-8: Rating one (1) has the most restrictions and rat-
ing eight (8) has the least restrictive.
Unlock : If you select unlock, parental control is not
active and the disc plays in full.
4. Press ENTER/OK to confirm your rating selection,
then press SETUP to exit the menu.
5. Press OPEN/CLOSE (/) to activate parental
control.
Note:
If you set a rating for the player, all disc scenes with the same
rating or lower are played. Higher rated scenes are not played
unless an alternate scene is available on the disc. The alterna-
tive must have the same rating or a lower one. If no suitable
alternative is found, playback stops. You must enter the 4-digit
password or change the rating level in order to play the disc.
All manuals and user guides at all-guides.com
1-26

Password (Security Code)

You can enter or change password.
1. Select "Password" on the LOCK menu then press B.
2. Follow step 2 as shown left column (Rating).
To change the password, select the "Change", press
ENTER/OK and input the new 4-digit code then
press ENTER/OK. Input it again to verify.
3. Press SETUP to exit the menu.
If you forget your Security Code
If you forget your security code you can clear it
using the following steps:
1. Press SETUP to display the Setup menu.
2. Input the 6-digit number "210499"
and the security code is cleared.
3. Enter a new code as described above.

Area Code

DVD
Enter the Area Code whose standards were used to
rate the DVD video disc, based on the list in the
reference chapter (see page 37).
1. Select "Area Code" on the LOCK menu then press
B.
2. Follow step 2 as shown left (Rating).
3. Select the first character using v / V buttons.
4. Press B and select the second character using
v / V buttons.
5. Press ENTER/OK to confirm your area code
selection.