Page 2
If you lend your product to another party, inform that party of the safety-related operating pro- cedures and hand over this assembly guide. If you require additional copies of this manual, you can obtain them free of charge from TW AUDiO or download them from www.twaudio.de Instructions in this user manual...
Page 3
TW AUDiO reserves the right to update this document based on recent developments. TW AUDiO GmbH Osterholzallee 140 71636 Ludwigsburg Germany Phone : + 49 (0) 71 41-48 89 89 0 Fax: + 49 (0) 71 41-48 89 89 99 E-Mail: info@twaudio.de WWW: www.twaudio.de...
Operation manual B10 1. Safety | Intended use Please adhere to the following safety instructions to avoid risks when operating loudspeakers. The B10 loudspeaker was developed for use in professional sound systems. The loudspea- ker may only be used by trained and qualified personnel. Note the operating modes described in this operating manual.
Page 6
Operation manual B10 Ensure that the loudspeaker is not exposed to permanent thermal overloads. Thermal over- loads may cause a fire and result in serious personal injury and property damage. WARNING Note that TW AUDiO does not provide a warranty for damage that can be attributed to this type of overload and therefore cannot be held liable for any secondary damage.
Operation manual B10 2. Overview Components B10 passive B10 active Figure 2.1 - Overview 10“ cone driver 15 mm multiplex housing – Warnex texture paint surface finish M20 pole mount flange for attaching a distance rod Milling for rubber feet for safely stacking loudspeakers Ergonomic carrying handle (top and bottom) Standard connection panel Type label...
(ACTIVE model) and B10P (PASSIVE model). 2.2.1 B10A / B10P model The standard version of the B10 loudspeaker is the B10A variant which can only be operated in „ACTIVE“ mode. It comes with a standard connection panel. The separation takes place in the amplifier DSP.
NL4 pins reversed LINK components: 1 x 10" prog. power: 700W impedance: SPL max.: 123 dB frequency range: 40Hz - 200Hz weight: 20.1 kg S/N: Made in Germany Read manual before use ! www.twaudio.com Figure 2.3.1.1 - Overview operation MONO...
20.1 kg S/N: Made in Germany Read manual before use ! www.twaudio.com Figure 2.3.1.2 - Overview 2.3.2 Selector switch S1 and S2 - TOP OUTPUT mode The two vertical selector switches ( see figure 3.2.3 - S1 and S2) activate the respective high pass output.
Operation manual B10 4. Commissioning Setup The B10 loudspeaker is designed for standing operation. Make sure that all system structures are located on a firm, level surface and that the surface can bear the total weight! WARNING Ensure that the loudspeakers are securely attached to prevent personal injury and prop- erty damage.
Page 14
Operation manual B10 Before setting up the system outdoors, consider unexpected wind conditions at the opera- tion site! Disassemble your system immediately when wind speeds exceed 8 bft (34 to 40 kn / 62 to WARNING 74 kph / 38.5 to 46 mph) and secure the system components! Make sure that there are no persons in the immediate vicinity of the system structure! Make sure that the system structures are not operated over the audience at wind speeds in excess of 6 bft (22 to 27 kn / 39 to 49 kph / 24.2 to 30.45 mph) and that there are no persons...
Operation manual B10 Operation Operation of the B10A speaker requires a DSP-Controller. TW AUDiO recommends opera- ting the B10P loudspeaker on a DSP-Controller. For this purpose, only presets developed by TW AUDiO are recommended. The TW AUDiO system racks are ideally suited for this purpose.
Operation manual B10 5. Transport and storage Due to the B10 loudspeaker weighing over 20 kg [44.09 lbs.], two persons are required to handle and transport the unit. To enable a single person to transport several multiple B10 loudspeakers, TW AUDiO recom- mends using the QDB10 quad dolly.
EC directives. This declaration becomes invalid in case of modifications that have not been approved by us. This declaration applies to the following components • B10A • B10P as well as all model variants based on these, provided that they correspond to the original factory models and have not been technically modified in any way.
Operation manual B10 7. Disposal It is prohibited to dispose of used electrical equipment with household refuse. All TW AUDiO GmbH products are so-called B2B-products. This means that they are sold by a commercial business to a commercial business. TW AUDiO products that bear the trash can symbol shown here may only be disposed of by TW AUDiO.
Need help?
Do you have a question about the B10A and is the answer not in the manual?
Questions and answers