Ferno ADVANTAGE PRO User Instructions

Australia
HARNESS DESIGNATION:
GENERAL USE:
SUGGESTED APPLICATIONS:
COMPLIANCE

ATTACHMENT POINTS

Ensure you are familiar with all the attachment points on
this harness and their limitations. Each attachment point is
labelled appropriately.
Fall Arrest Attachment Points
1. Rear dorsal D-ring is rated as a fall arrest attachment point
2. Extension strap on rear dorsal D-ring is rated as a fall
arrest attachment point
3. One front 'O' ring attachment point. Ensure you feed
adjustment male buckle (the one with the tongue)
through the back of the "O" ring and connect to the
female buckle.
Pole Strap Attachment Points
The large aluminium rings on the thighs are rated as Pole
Strap attachment points only. The connection rings must
be loaded equally with a pole strap as approved by Ferno
Australia. Do not connect to one ring only.
FRONT VIEW OF HARNESS AND FEATURES
Neoprene Buckle
Protector on chest
straps
Central Front Fall
Arrest/Rescue/Ab-
seil Attachment
Point
Adjustable straps
for centralising
Front Attachment
Point
Front Fall Arrest
Attachment Strap
& Leg Strap Quick
Connect Buckles
Colour-coded
buckles:
RED = Front
adjustment buckle
BLACK = Leg strap
buckle
HEAD OFFICE: 11 Johnstone Road, Brendale, QLD 4500
Toll Free: 1800 804 647 | Tel: +61 7 3881 4999 | Email: sales@ferno.com.au | www.ferno.com.au
(VHI ADVANTAGE PRO)
FALL ARREST HARNESS
Safety harness for use in situations where there is a risk of free fall
Tower; Pole work; Rescue; Abseil
Complies with AS/NZ 1891.1
(refer notes on Energy Absorbers)
Rear Dorsal
Fall Arrest
Extension
Attachment
Point
Splash proof
and water
resistant
webbing
Pole Strap
attachment
point on
either side of
harness
AdvantagePro Instructions: ID# 00152-V1- 08/2012
ADVANTAGE PRO HARNESS
USER INSTRUCTIONS

ENERGY ABSORBING LANYARDS

A Ferno energy absorbing lanyard must be used to connect
into a fall arrest attachment point. NOTE: The lanyard used
on the Dorsal Extension must not exceed 1.6 m in length.
WARNING
1. A lanyard assembly should be secured to an anchorage
point that is at a level which will result in the minimum
free fall and the least total fall distance consistent with
the wearer's ability to carry out work tasks. The maximum
allowable free fall is no more than 2 m.
2. Energy absorbers that absorb energy by permanent
deformation or destructive action should be discarded if
that process has commenced.
REAR VIEW OF HARNESS AND FEATURES
Rear Dorsal "D" At-
tachment Point with
extension and neoprene
protective cover
Rear Gear/
Equipment
Loops
Removable
Shoulder Pad
with reflec-
tive grey
material
Wide com-
fortable Waist
Belt with
reflective
& photolu-
minescent
(glow-in-the-
dark) material
Wide one-
piece leg
supporting
loops
1