Ordering Replacement Parts; Preventive Maintenance; Safety Features; Controller Leds - Siemens 125-1957 Owner's Manual

APOGEE Heat Pump Controller – Multi-Stage Owner's Manual

Ordering Replacement Parts

If a controller is not operating correctly, order a new controller. The product number for
ordering a replacement controller is the controller product number preceded by an "R". The
replacement product numbers for accessories are the same as new product numbers:
Unit Vent Controller – 0 to 10V Output
CE Compliant Unit Vent Controller – 0 to 10V Output

Preventive Maintenance

Most controller components are designed so that, under normal circumstances, they do not
require preventive maintenance. Periodic inspections, voltage checks, and point checks are
normally not required. The controller's rugged design makes most preventive maintenance
unnecessary. However, devices that are exposed to dusty or dirty environments may require
periodic cleaning to function properly.

Safety Features

The controller board stores the controller's address, applications and point values. In the
event of a power failure or a reset, these values are retrieved from the controller's permanent
memory and are used by the controller unless overridden by a field panel. If one of the
following conditions occurs, the controller will activate safety features present in its fail-safe
mode.
•
Sensor failure.
•
Loss of power. Upon controller power loss, communication with the controller is also
lost. The controller will appear as failed (

Controller LEDs

To determine if the controller is powered up and working, verify that the Basic Sanity Test
(BST) Light Emitting Diode (LED) is flashing ON/OFF once per second. The controller
contains eleven LEDs located on the circuit board. See the Controller LED indicators section
of Chapter 1, Product Overview for more information about LEDs.
NOTE:
32
The TX and RX LEDs indicate communication over the FLN.
540-509
550-509
) at the field panel.
*F*
Siemens Building Technologies, Inc.