Operation Of 12 V Dc Appliances - Eliminator 011-2002-8 Instruction Manual

OPERATION OF 12 V DC
APPLIANCES
1. Check the battery capacity %
indicators to ensure the battery is
fully charged. Refer to Important
information
2. Plug the DC appliance's power
cord (1) into the 12 V DC outlet (2)
of the power pack (fig C).
g C
1
01 1-2
00 2-8
P o w e
rB o x
O n d u
le u r-
b lo c
1 2 0 W
3 0 0
NOTE:
The power pack can only operate 12 V DC appliances that draws 10 A or less from its
DC socket. Please disconnect the 12V DC appliances after use to avoid over discharge of
power pack internal battery.
CAUTION! EQUIPMENT DAMAGE
• While the DC appliance is operating, the combined load of the
appliances including the power pack's LED light and USB port
must not exceed 115 W.
• The DC outlet does not turn OFF automatically even when
the internal battery is almost discharged. It is therefore
recommended to turn ON the AC outlets while operating a DC
appliance. Turning ON the AC outlets enables the power pack to
raise an alarm when the internal battery charge goes low.
page 13.
2
P o w e
r P a ck
d 'a li m
W it h
e n ta ti
In v e rt
o n P o w e
e r
rB o x
In ve rte MD
r
On du
le ur
Cr an k
As sis
am pè
t AM PS
re s au
dé m ar
ra ge
MM-112002-04
3. Turn ON the DC appliance.
4. Recharge the power pack
immediately after use. Refer
to Recharging the power pack
battery page 25.
19