Desert Aire Aura QS Installation And Operation Manual page 10

10
Desert Aire - QS/QV Manual
• All Products (QV and QS)
Personnel should avoid stepping on the top of the unit. Desert Aire
dehumidifiers are not designed to support the weight of a person on all
portions of the roof. Damage incurred through caved or distorted top panels
will not be covered under warranty. If you must walk on the top panels,
carefully walk on the edges where structural integrity is greatest.
• VerticalAire™ Products (QV)
- 4-15 Ton
Move the unit to the desired installation location with the unit on the
wood skid. To remove unit from skid, position fork lift parallel to the
boards on the top of the skid. Carefully slide forks between the unit
and cross braces to pick the unit off the skid. The unit will have to be
carefully removed from the fork lift and placed into the desired
location using hand truck equipment dollies or pipe rollers. Use
caution to not damage the unit with the fork lift or tip the unit over
ensuring it is kept as level as possible.
- 20-30 Ton
The base is equipped with a built-in 12 gauge skid. Use a fork lift to
move the unit into place. Use caution to not damage the unit with the
fork lift or tip the unit over ensuring it is kept as level as possible. In all
cases, use appropriate safety practices while lifting the unit. Forklift
tie-down clamps, straps, and other restraints where applicable should
be used to prevent tipping of the load.
• Aura™ and TotalAire™ Products (QS)
Aura™ and TotalAire™ dehumidifiers are equipped with four or more lifting
points. Use spreader bars and safety straps when you rig the equipment.
- Utilize all of the lifting lugs provided when hoisting the unit.
- Test-lift the dehumidifier to verify that it is properly balanced.
- Refer to diagram below for additional lifting instructions.