Advertisement
Quick Links
INSTALLATION INSTRUCTIONS FOR SURFACE MOUNTED PANIC EXIT DEVICES
PARTS LIST
1. Outside Body
2. Rubber Escutcheon
3. Hex Bolts
4. Flat Spindle
5. Spindle with twist (35°) (R & L)
6. Spindle with twist (45°)( R & L)
7. Screw x 30 mm.
8. Screw x 40 mm.
9. Wafer, blue
10. Wafer, red (active)
11. Washer, flat
12. Finish Washer
13. Tweezer
These combination locks are designed to replace your keyed cylinder on panic exits. They will work with most
panic exits with a 90° turn radius or less. They may need some modifications to work with some panic bars.
Because so many panic exit devices are manufactured under different brand names we cannot identify all panic bars
that our locks are compatible with.
Set Combination:
Set the code to desired combination before placing to door. Use How to Change Code instructions to change code.
Be sure to hold the "C" (clear bottom) while changing code.
Installation:
The 310P panic exit device is set up and ready for clockwise or counter clockwise operation. It may, however; need
to be calibrated for use with the specific panic exit device.
The 115P and 285P panic exit device is set up for replacement or new installation with Lever operation. It may,
however need to be calibrated for use with the specific panic exit device.
Position on Door:
1.
After panic exit is installed on door, determine the center of the tail piece hole on the outside of door. Place
the template over the center hole from the standard rim cylinder 1 ¼". Mark top and bottom mounting holes
to mount the combination body to the door. The center hole will be where the tail piece is to be placed, from
combination body to panic bar.
2.
Drill mounting holes:
a.
New Installation: Drill either 3/8" mounting holes at the top and bottom for the lock mounting,
and a 1 ¼" hole in the lower center tail piece hole, (whichever is most convenient)
b.
Retro Fitting: If the current hole is 2" or less, proceed with paragraph 3. If existing hole is larger
than 2 ½" you may need a larger escutcheon to cover the existing hole, or purchase the push / pull
plate from LockeyUSA to cover a large hole in the door.
3.
Place the rubber escutcheon on the back of the lock body and mount the combination lock to the door using
the supplied finish washers and screws.
LOCKEY® DIGITAL DOOR LOCK
KEYLESS ACCESS CONTROL
MODELS: 310P – 285P – 115P
1
310-P 285-P 115-P
1
1
1
1
1
1
2
2
4
1
0
0
2
2
2
0
2
2
2
2
4
2
2
4
2
2
2
2
2
2
2
2
4
2
2
4
1
1
1
Advertisement
Related Manuals for LOCKEY 310-P
Summary of Contents for LOCKEY 310-P
- Page 1 LOCKEY® DIGITAL DOOR LOCK KEYLESS ACCESS CONTROL INSTALLATION INSTRUCTIONS FOR SURFACE MOUNTED PANIC EXIT DEVICES MODELS: 310P – 285P – 115P PARTS LIST 310-P 285-P 115-P 1. Outside Body 2. Rubber Escutcheon 3. Hex Bolts 4. Flat Spindle 5. Spindle with twist (35°) (R & L) 6.
- Page 2 LOCKEY® DIGITAL DOOR LOCK KEYLESS ACCESS CONTROL INSTALLATION INSTRUCTIONS FOR SURFACE MOUNTED PANIC EXIT DEVICES MODELS: 310P – 285P – 115P After the lock is mounted to the door, place the proper spindle into center / spindle hole. You may need to use the right twist or left twist depending on the knob / lever turn direction.