Table of Contents
Advertisement
APPENDIX E - USER INTERFACE: DIGITAL DISPLAY DURING
EXTENDED GPS TEST
The following chart describes the display and audio-visual feedback the
beacon provides during extended GPS Test. The messages on the digital
display typically appear as one or two words at a time, until the entire
message has been displayed.
GlobalFix™ iPRO display, LED/ Audio Signaling and Description of Operation
LONG
The system informs you that the extended GPS test has initiated.
GIVE
The system reminds you that GPS data acquisition is optimized by giving the beacon a clear view
of the sky.
GPS
The system informs you that the beacon is in the process of performing the extended GPS test.
This message repeats for approximately 100 seconds while the GPS is acquiring data.
GPS
The system informs you that the beacon has passed the extended GPS test.
NMEA
This message appears if the extended GPS test has passed. The display indicates that the
external GPS has updated its coordinates.
LT: 26.03.033N LG: 80.10.066W
The system provides the user with the GPS coordinates acquired during a successful test.
Coordinates will scroll from right-to left.
NO
The system informs you that the beacon has failed the extended GPS test after 10 minutes.
SEE
This message appears if extended GPS test failed. The system advises you to refer to this
Product Support Manual (User Book) for information on what to do and who to contact.
TEST
The system informs you that the extended test is complete, and that the system is entering shut
down.
Y1-03-0233 Rev. D
GPS
DATA
CLEAR
TEST
TEST √
GPS
DATA
GPS
USER
BOOK
END
TEST
VIEW
long beep
G
long beep
R
START
TO
SKY
36
Advertisement
Table of Contents
