Installation - Datalogic SG-PSB Series Instruction Manual

SG-PSB INSTRUCTION MANUAL

INSTALLATION

LIGHT CURTAIN INSTALLATION
For light curtain alignment procedure, see the instruction manual of each specific model.
INSTALLATION OF SG-PSB WITH SG-DM
SG-PSB with
Receiver
1. Define the area to protect and the precise positions where the deviating mirrors and the
emitting and receiving units of the light curtain will be installed.
2. Install the SG-DM mirrors inside the suitable model of the SG-PSB, with the help of the
ST-PS-DM kit (see Fig. 6). The table "Corresponding Models" in the SG-DM manual
gives an overview of how to match products with deviating mirror models.
3. Once the mirrors have been installed inside the Protective Armor Stand, place the
Protective Stand in the established points. Fasten the supports (or SG-P) to the floor, in
the defined points, verifying that their axes are perpendicular to the floor; use the spheric
level provided to fine adjust their inclination if necessary.
4. Orient the mirrors to about 45° with respect to the optic path; the Protective stand
guarantees an adjustment interval around the vertical axis of about ±5° once secured to
the floor.
5. Insert the SG-LP laser pointer in the upper part of the emitting unit; orient the unit so that
the laser beam hits the surface of the first mirror in a central point of the vertical axis and
at the same height at which the pointer is installed.
6. Repeat the same procedure inserting the pointer in the lower part of the unit; if necessary
repeat these procedures until the desired result is achieved.
7. Orient the first mirror so that the laser beam hits the second mirror as described above.
For the angular adjustment, see the "Adjusting the inclination and the angular position of
the plates" section, if using the SG-PSB accessory with SG-DM mounted without the SG-
P kit. If the SG-P accessory is being used, adjust as specified in the "SG-P Accessory
Mounting" section.
8
SG-PSB with
Emitter
SG-PSB with
SG-DM
Fig. 9
SG-PSB with
SG-DM