After Use - Silvercrest SND 3600 D3 Operating Instructions Manual

Colour and brightness settings
♦ Adjust the colours and brightness as required by clicking on the
"Color/Brightness adjustment" button (K). A settings window
appears.
♦ Move the "Brightness" slider to set the brightness between
0 and 255.
♦ Move the three "Color Balance" sliders to set the RGB values
between 0 and 255.
♦ To reset to the default values, click on the "Default" button.
♦ To accept the new values and close the settings window, click on
the "Exit" button.

After use

♦ Remove the negative holder
the device.
♦ Remove the slide magazine
slot on the right.
4
♦ Remove the USB cable
and the scanner.
SND 3600 D3
by pushing it all the way through
5
by pulling it back out of the
6
from the USB port on your computer
8
GB │ MT │ 95 ■