Advertisement
PATTERN USE
Pattern size: E
Outside diameter: 37.5mm
Image area: 28mm diameter
The Accent Beamshaper is supplied with an internal pattern holder.
To fit your pattern, remove the internal pattern holder from its
magnetic mounting plate. Unclip the locking plate and insert the
pattern with correct orientation. Re-clip the locking plate and place
the pattern holder back on the magnetic mounting plate.
For custom gobos please ensure the Design is inside the 28mm
area
SAFETY AND MAINTENANCE
Keep your Philips Selecon Accent LED Beamshaper in top condition and performing at its best by cleaning it regularly with a
soft cloth. The Beamshaper lenses should only be cleaned with optical tissue paper.
The above is the only maintenance task that can be safely carried out by non approved personnel.
Philips Selecon has manufactured this luminaire in accordance with recognised best practices to recommended international
safety standards. It is your responsibility to maintain this luminaire in good and safe working condition.
Repairs should only be carried out by suitably qualified persons. Do not operate the luminaire with damaged lamps or cable,
etc. Consult your Philips Selecon distributor for assistance. Only replace damaged parts with authorised Philips Selecon
Accent spare parts.
Luminaire electrical cable – your Accent LED Beamspot is fitted with special heat resistant flexible
N.B.
cable, replace with genuine Accent spare part cable kit only – please refer to your Selecon distributor.
(Replacement cable kits are supplied complete with necessary terminal connectors).
ELECTRICAL INSTALLATION
WARNING!!!
Risk of fire and electric shock. This product is to be installed by a qualified electrician only. This luminaire
employs a grounded type receptacle and is not intended for connection to a two-wire, ungrounded source of
supply.
When installing this luminaire use wire conductor colour codes as follows
DIMMING
Local Dimming Version
Accent LED Beamshaper models with local dimming
CANNOT be installed and run on a dimmed power
supply/track.
If your Accent LED Beamshaper model includes a local
dimmer, ensure that the dimming knob on the Accent
power supply is at its "Full" position (completely
clockwise) to test fitting.
Mounting options include track adaptors, ceiling mount plate, suspension half coupler. For full details contact your Philips
Selecon dealer: www.seleconlight.com/distributors
Brown
- Phase, Live
Blue
- Neutral, Return
Green/Yellow
- Earth
FEB 2015
© 2015 Philips Selecon All Rights Reserved
:
DALI Version
Accent LED Beamshaper Dali models with no local
dimmer can be installed and run on a DALI track system.
.
Advertisement
