Advertisement
KEY OPERATING POINTS AND FEATURES
A: Beamshaper lid latch (Open this to insert
accessories and to clean the lenses)
B: Four non removable shutters. (These allow you to
mask portions of the beam, or to frame around pictures, etc.)
C: Shutter lock
D: Pattern/Gobo holder
E: Accessory slots - Various glass effects
and coloured glass can be used here*
F: Front Lens
G: Rear Lens
H: Lens focus knobs
I: Pan lock with reference scale and Allen key lock-off
J: Tilt lock with reference scale and Allen key lock-off
K: Rear lid locking clip
L: Potentiometer shaft for dimming option.
POWER SUPPLY
110-240VAC
Line Frequency 50/60 Hz
Power consumption: 13W
Colour Temperature: (2700K,3000K,4000K) (nominal) CRI: 95 (Typical)
Supply Current at 240V: 350mA
PAN TILT ADJUSTMENT
Adjusting the pan angle
Release the set screw above the
FOCUSING
ballast box (as shown) and
adjust accordingly. Re-lock after
adjustment.
The variable beam of your Accent
the front and rear lens in relation to each other. To move the
locking knobs and move them into the desired position and then tighten the locking knobs. The front lens defines the beam
spread; the rear, the focus degree of softness or sharpness of the beam edge or shutters. Finger tight pressure only is
necessary to lock the lens off in its chosen position.
The four shutters can be used to mask off portions of the beam, or to frame areas, etc.
D
B
G
Life: 35,000 hrs (L70)
THE
FEB 2015
© 2015 Philips Selecon All Rights Reserved
I
J
L
C
A
E
F
Power Factor at 100% : >0.95
Adjusting the tilt angle
The tilt can be adjusted by
BEAMSHAPER
unlocking the hex screw located as
shown. Re-lock after adjustment.
Beamshaper is altered by adjusting
lenses,
simply
K
H
A
loosen
the
lens
Advertisement
