Service Of Devices; Photosensor; Electrical Igniter Replacement; Pic. 12. Position Of Photosensor In Hybrid Burners - Pellas X HYBRID series User Manual

Photosensor in a burner should be cleaned from time to time with a damp, soft rug,
similarly to oil or gas burners. After removing the cover of a burner, the photosensor
should be removed from the socket (1), then it should be cleaned and installed again. After
executing the above activities, the cover of a burner should be mounted.
Frequency of cleaning the photosensor:
 Bakeries- once a month
 Boiler rooms – every 3 months
When the igniter does not heat even though the "firing up" message is shown, it is probably
damaged. To replace the igniter, remove the burner cover. On the right side of the fan, there is a
26 | P a g e

7. SERVICE OF DEVICES

Servicing of devices can only be
executed by switched off electrical
powering of a burner and a boiler.

7.1. Photosensor

Pic. 12. Position of photosensor in HYBRID burners.

7.2. Electrical igniter replacement.

ATTENTION!
.