ADURO DraftOptimizer User Manual And Installation Manual page 26

4. Removing the cords from terminal:
Press the terminal holders lightly with a pen or
the like, and at the same time lightly pull the
cords from the terminals.
After this, pull the whole cable out of the
cooling pipe and run the new cable into the
cooling pipe. Pull the cable through so there is
a good length of cable to work with.
5. Mounting of cords in terminal:
Strip the cable approx. 5 cm. Then strip each of
the end of the cords approx. 5 mm. The metal
wires are twisted/turned a few times so that the
twisted ends become straighter and firmer.
The cords are fastened to the terminals by
pressing the terminal holders and at the same
time pushing the ends of the cords into the
terminals. See illustration.
Make sure that the cord is pushed all the way into the terminal opening before you let go of the
terminal holder.
The cooling unit is assembled and the parts are mounted in reverse order.
23