Approval And Conformity; Notes On Pc And Modem Operation; Notes On Gigaset Repeater - Gigaset M101 Data Operating Instruction

21.4.99

Approval and conformity

Notes on PC and modem operation

Notes on Gigaset Repeater

6
gigam101.fm5
Gigaset V.24 Adapter dt/eng:A30853-X400-B104-3-74D1
Your Siemens Gigaset M101 Data has been certified by the Ger-
man Federal Office of Telecommunication Approval (BZT). This
equipment has been approved in accordance with the EU direc-
tive 91/263/EC Telecommunication Terminals.
This data terminal complies with the requirements of the EU di-
rectives:
89/336/EC EMC Directive
72/23/EC Low Voltage Directive
and thus carries the CE mark.
When using a modem, software malfunctions in the PC
(e.g. an operating system crash or program errors in the
application software) can prevent the cleardown of a
modem connection from a telephone line. You incur
connection costs for trunk lines that you seize!
Since your Gigaset M101 Data only replaces a serial ca-
ble, malfunctions of this kind can also occur here. If such
a problem occurs, check the status of your modem and,
if applicable, reset it.
In the case of one-sided interruption of the mains supply
or complete interruption of your Gigaset M101 Data's
hop, the interface's status lines are reset to the initial
status in the partner station within 2 minutes (a modem
then clears down the connection).
Whenever possible, operate the station registered as
user at your PC (lokale Station), since any malfunctions
on the user side can be displayed, for technical reasons,
more quickly than at the base, see "LEDs and buttons"
on page 19.
Should the graphic or sound card be affected by interfer-
ence from Gigaset M101 Data, rotate Gigaset M101
Data until the interference is removed.
The Gigaset Repeater cannot be used to extend the
radio range.
The repeater was designed for use behind Gigaset 2000
base stations.