Table of Contents
Related Manuals for matev SPR-H/M 125 IX
Summary of Contents for matev SPR-H/M 125 IX
- Page 1 GmbH Nürnberger Str. 50 90579 Langenzenn T +49 (0) 9101 9087 -0 F +49 (0) 9101 9087 -20 info@matev.eu www.matev.eu Original Operating Manual SPR-H/M 125/250/400 IX/ST Electronic Spread Rate and Spread Width Control Device...
-
Page 2: Table Of Contents
Table of contents About this operating manual ..................3 Safety ......................... 4 Intended use ....................... 4 General safety instructions ..................4 Installation ......................... 5 Installation of the spread rate regulator ............... 5 Installation of the spread width regulator ..............8 Mounting and dismounting the combination device ............. -
Page 3: About This Operating Manual
About this operating manual About this operating manual Dear customer! Thank you for purchasing this implement, we appreciate your trust. Prior to using this implement for the first time, read this operating manual carefully and conscientiously all the way through. Keep this operating manual where it is easily accessible. -
Page 4: Safety
Intended use This device is an electronic spread rate and spread width regulator for the type of matev spreaders specified on the cover page and it is available for spread rate regulation, spread width regulation, or as a combination device for regulation of spread rate as well as spread width. -
Page 5: Installation
Installation Installation Attention! Before starting up the implement, read the instructions on safety and han- dling for operation of the entire implement and connection to the tractor. Installation of the spread rate regulator Switch off the tractor and remove the ignition key. ... - Page 6 Installation Attention! risk of collision! Remove bolt! Remove the red colored bolt in the picture Fig 3: Remove bolt! Mount the electric cylinder. Holder Electric cylinder Fig. 4 Electric cylinder...
- Page 7 Installation Use spacer bushes Fig. 5 Spacer bush Connect pushers to the piston rod of the electric motor. Use spacer rings Fig. 6 Spacer ring Fig. 7 Pushers coupled Lay out the cable from the electric cylinder to the control device. You can fasten the control device on any iron part in the cab, using the magnetic base.
-
Page 8: Installation Of The Spread Width Regulator
Installation Installation of the spread width regulator Dismount the shackle on the spread apron, turn it 180° and refasten it. Shackle Fig. 8 Spread apron Mount the electric cylinder. Fig. 9 Hydraulic connections - spread width regulator Lay out the cable from the electric cylinder to the control device. You can fasten the control device on any iron part in the cab, using the magnetic base. -
Page 9: Operation
Take the parts to the collection points for residual waste, spe- cial waste, or recycle them depending on material. matev GmbH does not provide any disposal services. Guarantee The general delivery conditions of matev GmbH apply. -
Page 10: List Of Illustrations
List of illustrations Fig 1 Holder - electric cylinder Fig 2 Holder on the spreader ..............5 Fig 3: Remove bolt! ............................6 Fig. 2 Electric cylinder ............................6 Fig. 3 Spacer bush ............................7 Fig. 4 Spacer ring ............................7 Fig. 5 Pushers coupled ..........................7 Fig.
Need help?
Do you have a question about the SPR-H/M 125 IX and is the answer not in the manual?
Questions and answers