Advertisement
USB OPERATION
- PRESS USB-MP3 BUTTON TO TURN ON USB MODE WITH USB INDICATOR IS LIGHT ON.
- INSERT THE USB DEVICE INTO THE USB SOCKET ON THE SYSTEM, THE PLAYER WILL
START PLAYING THE TRACKS.
- PRESS THE
OR
BUTTONS TO CHOOSE YOUR DESIRED TRACK.
- PRESS
THE
BUTTON TO PAUSE OR PLAY THE TRACK.
- PRESS THE STANDBY/ON BUTTON TO TURN OFF THE UNIT WHEN YOU ARE DONE.
NOTE
- THE USB-MP3 PLAYING MODE HAS MEMORY FUNCTION. WHEN RE-INSERTING THE
SAME USB DEVICE, IT WILL RESUME THE TRACK PLAYING FROM THE LAST TIME.
- THE UNIT IS ONLY PLAYING THE MP3 FORMAT TRACKS.
REMOVING THE USB DRIVE
-
PLEASE BE SURE THE STOP PLAYBACKS AND TURN THE UNIT OFF BEFORE
REMOVING THE USB DRIVE TO AVOID DAMAGE TO THE USB AND THE SYSTEM.
BLUETOOTH OPERATION
-
PRESS BT BUTTON ON THE FRONT PANEL TO ACTIVATE THE BLUETOOTH MODE WITH
BT INDICATOR IS LIGHT ON.
- SET UP THE BLUETOOTH PLAYBACK DEVICE AND SEARCHING FOR "BT TURNTABLE"
AND CONNECT.
- IF ASKED FOR A PASS CODE, ENTER "0000"
*THIS IS A ONE-TIME EVENT PER DEVICE. TO PAIR YOUR UNIT TO ANOTHER DEVICE,
REPEAT THE ABOVE PREPARATION AND CONNECTION STEPS.
- YOU WILL HEAR A SIGNAL WITH DING-DONG SOUND.
- ENJOY YOUR MUSIC FROM YOUR PLAYBACK DEVICE.
NOTE
- THE NEXT TIME YOU TURN ON THE DEVICE IT WILL AUTOMATICALLY CONNECT TO THE
LAST BLUETOOTH PLAYBACK DEVICE CONNECTED. IF YOUR BLUETOOTH PLAYBACK
DOES NOT AUTOMATICALLY RECONNECT TO THE DEVICE, YOU WILL HAVE TO
RE-ESTABLISH THE CONNECTION TO YOUR BLUETOOTH DEVICE MANUALLY.
- IF YOU USE A SMART-PHONE AS YOUR BLUETOOTH PLAYBACK DEVICE, THE AUDIO
FILE WILL MUTED WHEN THERE IS AN INCOMING CALL. ACCEPTANCE/ TERMINATION
OF THE CALL IS CARRIED OUT VIA THE SMART PHONE. AFTER FINISHING THE CALL,
THE PLAYBACK WILL BE RESUME AUTOMATICALLY.
E-9
LINEOUT OPERATION
- THIS SYSTEM INCLUDED A SET OF LINE OUT JACK WHICH ALLOW TO PLAY FROM
THE BT, USB-MP3 AND PHONOGRAPH OF THIS SYSTEM TO AN EXTERNAL PLAYBACK
DEVICE.
- INSERT THE AUDIO CABLE (L/R RCA CABLE, NOT INCLUDED) INTO THE "LINE OUT"
SOCKET OF THE UNIT.
- OPERATE THE UNIT AS USUAL.
- IN ORDER TO ACHIEVE BEST EFFECT IN SOUND, ADVISE SETTING THE UNIT VOLUME
INTO MINIMUM LEVEL.
- THROUGH THE SPEAKERS OF EXTERNAL PLAYBACK DEVICES, WE CAN HEAR THE
SOUND FROM THE UNIT.
HEADPHONE OPERATION
- THE STEREO HEADPHONE JACK IS LOCATED ON THE BACK PANEL. CONNECT A SET
OF STEREO HEADPHONES (NOT SUPPLIED) TO THIS JACK FOR PRIVATE LISRENING.
WHEN HEADPHONE ARE IN USE, THE SPEAKERS WILL BE AUTOMATICALLY MUTED.
- WHEN USING HEADPHONES, ALWAYS SET THE VOLUME CONTROL TO A LOW LEVEL
BEFORE YOU PLUG-IN THE HEADPHONE JACK, THEN PLUG-IN THE HEADPHONE
JACK AND GRADUALLY INCREASE THE VOLUME TO A COMFORTABLE LISTENING
LEVEL.
REPLACING THE STYLUS
- LIFT THE TONE ARM OFF THE TONE ARM REST.
- AT THE FRONT END OF THE TONE ARM, PLACE THE TIP OF YOUR FINGERNAIL
BETWEEN THE RED STYLUS NOLDER AND THE BACK CARTRIDGE HOUSING AS
SHOWN, PRESS ON THE RED STYLUS HOLDER UNIT IT SEPARATES FORM THE
CARTRIDGE HOUSING.
- COMPLETELY REMOVE THE RED STYLUS HOLDER WITH WORN STYLUS AND
DISCARD IT.
- PLACE THE NEW RED STYLUS HOLDER WITH STYLUS UNDER THE CARTRIDGE
HOUSING. FIRST, PRESS UPWARD ON THE BACK SIDE OF THE STYLUS HOLDER,
AND THEN PRESS UP ON THE FRONT EDGE OF THE STYLUS HOLDER UNTIL IT
SNAPS INTO PLACE ON THE CARTRIDGE HOUSING.
E-10
Advertisement
