Advertisement
13.PROTECTIVE ATTACHMENT PLUG - THE APPLIANCE IS EQUIPPED WITH AN
ATTACHMENT PLUG HAVING OVERLOAD PROTECTION. THIS IS A SAFETY
FEATURE. SEE INSTRUCTION MANUAL FOR REPLACEMENT OR RESETTING
OF PROTECTIVE DEVICE.IF REPLACEMENT OF THE HAS THE SAME
OVERLOAD PROTECTION AS THE ORIGINAL PLUG.
14.CLEANING - THE APPLIANCE SHOULD BE CLEANED ONLY AS RECOMMENDED
BY THE MANUFACTURER.
15.POWER LINES - AN OUTDOOR ANTENNA SHOULD BE LOCATED AWAY FROM
POWER LINES.
16.OUTDOOR ANTENNA GROUNDING - IF AN OUTSIDE ANTENNA IS CONNECTED
TO THE RECEIVER,BE SURE THE ANTENNA SYSTEM IS GROUNDED SO AS TO
PROVIDE SOME PROTECTION AGAINST VOLTAGE SURGES AND BUILT UP
STATIC CHARGES.
17.NONUSE PERIODS - THE POWER CORD OF THE APPLIANCE SHOULD BE
UNPLUGGED FROM THE OUTLET WHEN LEFT UNUSED FOR A LONG PERIOD
OF TIME.
18.OBJECT AND LIQUID ENTRY - CARE SHOULD BE TAKEN SO THAT OBJECTS
DO NOT FALL AND LIQUIDS ARE NOT SPILLED INTO THE ENCLOSURE
THROUGH OPENINGS.
19.DAMAGE REQUIRING SERVICE - THE APPLIANCE SHOULD BE SERVICED BY
QUALIFIED SERVICE PERSONNEL WHEN:
A. THE POWER SUPPLY CORD OR THE PLUG HAS BEEN DAMAGED OR
B. OBJECTS HAVE FALLEN OR LIQUID HAS BEEN SPILLED INTO THE
APPLIANCE OR
C. THE APPLIANCE HAS BEEN EXPOSED TO RAIN OR
D. THE APPLIANCE DOSE NOT APPEAR TO OPERATE NORMALLY OR EXHIBITS
A MARKED CHANGE IN PERFORMANCE OR
E. THE APPLIANCE HAS BEEN DROPPED OR THE ENCLOSURE DAMAGED
20.SERVICING - THE USER SHOULD NOT ATTEMPT TO SERVICE THE APPLIANCE
BEYOND THAT DESCRIBED IN THE OPERATING INSTRUCTIONS. ALL OTHER
SERVICING SHOULD BE REFERRED TO QUALIFIED SERVICE PERSONNEL.
The device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the product.
NOTE: This product has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This product generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If the product does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures
: -Reorient or relocate the receiving antenna. -Increase the separation between the product and receiver. -
Connect the product into an outlet on a circuit different from that to which the receiver is connected. -
Consult the dealer or an experienced radio/TV technician for help.
E-3
LOCATION OF CONTROLS
Phonograph Lid
support Bracket
Speaker
VOLUME
Control
Handle
FRONT PANEL
USB Socket
USB PLAYER
Indicator
STANDBY/ON
Indicator
USB-MP3
PLAYER Button
STANDBY/ON
Button
PHONO-REC
Button
E-4
Phonograph Lid
Speaker
Latch
PHONO PLAYER/
REC Indicator
BT Indicator
PHONO PLAYER
Button
BT Button
Advertisement
