Network - Siemens SL42 Owner's Manual

66
Menu ! Setup !
Security !
then select a function:
PIN control
The PIN is usually requested each
time the phone is switched on. You
can deactivate this feature but you
risk unauthorised use of the phone.
Some Service Providers do not
permit this function.
Prevent new SIM
(Phonecode)
Your phone is prevented from
operating with a different SIM card.
Pin change
PIN 1
You can change the PIN to any
4 - 8 digit number (i.e . a number you
may find easier to remember).
Enter old PIN.
J
OK
Press.
OK Enter new PIN.
/
J
OK Repeat new PIN.
/
J
PIN 2
You can change the PIN 2 to any 4-8
digit number (displayed only if PIN2
is available).
Proceed as with PIN 1 .
Phonecode
You can also change the phone code
to any 4 - 8 digit number. Proceed as
with PIN 1 .
Setup

Network

Menu ! Setup ! Network !
Connection
This function is only displayed if it is
supported by the Service Provider.
Two independent phone numbers
must be registered on the phone.
Select
Select the phone number to be
used.
If you change frequently, it is more
convenient to make the selection
using the soft key (see p. 71).
L
Special settings can be made for each
phone number (melody, call diversion etc).
Switch to the required phone number first.
To switch the phone number/line:
(in standby mode)
0
Line 1
Lock
(Phonecode)
You may limit usage to one phone
number.
then select a function:
Display the active phone
number.
Press, then:
Press.
~