Windshield & Roof Console - Mitsubishi Outlander PHEV 2019 Owner's Handbook Manual

WINDSHIELD & ROOF CONSOLE
18
PROGRAMMING A NEW HOMELINK
To program HomeLink
®
you need to be at the same location as the device.
1. Press the HomeLink
orange slowly.
2. Position the end of your hand-held transmitter (B) 1 to 3 inches away from the HomeLink
while keeping the indicator light in view.
3. Press and hold the hand-held transmitter button while watching the indicator light (A). Continue
pressing the button until the indicator light (A) changes from slowly flashing orange to either
rapidly flashing green (rolling code) or continuously lit green (fixed code). Now you may release the
hand-held transmitter button.
4. Press the just-trained HomeLink
indicator light.
• If the indicator light stays on constantly green, programming is complete and your device
should operate when the HomeLink
• If the indicator light rapidly flashes green, firmly press, hold for 2 seconds and release the
programmed HomeLink
depending on the brand of the garage door opener (or other rolling code equipped device),
repeat this sequence a third time to complete the programming process. At this point if your
device operates, programming is complete.
• If the device does not operate, continue with "Programming a new HomeLink
complete the programming of a rolling code equipped device.
5. At the garage door opener receiver (motor-head unit) in the garage, locate the "Learn" or "Smart"
button. This can usually be found where the hanging antenna wire is attached to the motor-head
unit (see the garage door opener manual to identify the "Learn" button.
6. Firmly press and release the "Learn" or "Smart" button. (The name and color of the button may vary
by manufacturer.) There are typically 30 seconds to initiate step 7.
7. Return to the vehicle and firmly press, hold for 2 seconds and release the programmed HomeLink
button. Repeat the "press/hold/release" sequence a second time, and, depending on the brand of
the garage door opener (or other rolling code equipped device), repeat this sequence a third time
to complete the programming process. HomeLink
equipped device.
NOTE: Some hand-held transmitters may actually train better at a distance of 6 to 12 inches. Keep this
in mind if you have difficulty with the programming process.
®
to operate a garage door, gate, or entry door opener, home or office lighting,
button that you would like to program. The indicator light (A) will flash
®
button and observe the
®
button is pressed and released.
®
button. Repeat the "press/hold/release" sequence a second time, and,
®
should now activate your rolling code
®
button
®
1 - HomeLink
2 - HomeLink
3 - HomeLink
" steps 5 to 7 to
®
®
button 1
®
button 2
®
button 3
®