Scanstrut SPH-8-W Installation Instructions

Helm pod

Advertisement

Scanstrut Scanpod Installation Instructions
IMPORTANT
Helm Pods are only compatible with marine electronics devices as stated in the latest Scanstrut Product Guide – subject to change
without prior notice.
Use with unapproved products, or overloading, invalidates any warranty.
No liability is accepted for damage caused by incorrect installation.
The installation and assembly must be regularly inspected for evidence of damage or loose parts.
This product has been designed specifically for the mounting of approved marine electronics devices under normal boating
conditions.
HELM POD
This product is designed to be fitted to pedestal guards manufactured from stainless steel tubing, Ø25-33.7mm [1"- 1.33"] with wall
thicknesses of 1.5mm[1/16"] minimum.
For installations that differ from those stated here, please consult Scanstrut head office.
®
INSTALLATION SOLUTIONS FOR MARINE ELECTRONICS

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SPH-8-W and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Scanstrut SPH-8-W

  • Page 1 Scanstrut Scanpod Installation Instructions IMPORTANT Helm Pods are only compatible with marine electronics devices as stated in the latest Scanstrut Product Guide – subject to change without prior notice. Use with unapproved products, or overloading, invalidates any warranty. No liability is accepted for damage caused by incorrect installation.
  • Page 2 01-02-11 Issue 1 Parts List Tools Required Short Saddle Pack Long Saddle Pack Pod Back 60541 190SPH3 Jigsaw/Spiral 60453 SPH-8 60042 SPH-12,15,SYSTEM 60043 For ø25mm (1“) tube: ø20mm (25/32”) hole saw 1x 190SPH3 For ø32mm (1 1/4”) tube: ø25mm (1”) hole saw 2x 190SPH3 Hole Saw ø25mm (1")

Table of Contents