Settings Operation; Setting Items; Mode Select (Mode Select) - Fujitsu CG-641 Series Operation Manual

Settings Operation

This device is equipped with an OSD (On Screen Display) feature. Operate as follows to
change settings using the menu.
1. Press and hold the function setting switch on the back panel for about two seconds. (Figure
1 ).
2. The settings screen shown in figure 7-1 is displayed.
3. Move the cursor to the item that you want to change using the switch. The selected menu is
displayed.
4. Adjust the setting value of the item you want to change.
5. Move the cursor to "END" to finish the settings and press the switch.
Move the cursor to "RETURN" to return to the previous item and press the switch.
MAIN MENU
MODE SELECT
EXPOSURE SET.
FUNCTION SET.
CAMERA SETUP
LENS SETUP
MODE SAVE
BLEMISH COMPENSATION
INITIALIZE
Figure 7-1 MAIN MENU
Note)
If the menu is not operated for one minute, the menu will automatically turn off.
The setting for each item is saved when "RETURN'' and "END" are selected.
* is displayed for the items limited based on the setting of a function.

Setting Items

(1) Mode Select (MODE SELECT)

Camera is operated using the preset settings by selecting the various modes.
It is possible for the user to register user determined settings (USER MODE).
Refer to "MODE SAVE" for the setting procedure for "USER MODE".
The following modes can be selected.
STANDARD
HIGHWAY
CASINO
USER MODE
→
→
→
→
→
END
MODE SELECT
Figure 7-2 MODE SELECT menu
STANDARD
HIGHWAY
CASINO
USER MODE
RETURN END
En-12